3 digit TV codes for Dish Network remote controls
There are programming instructions for Dish Network 20.0, 20.1, 21.0, 21.1, 10.1, 8.0, 5.4, 6.4, 4.4, 4.3, 1.5, Platinum and Platinum Plus.There are remote controls.
For about 3 seconds, press and hold the mode button for the device you want the remote to control.The mode button should be released when all the other buttons light up.
The buttons on the number pad allow you to enter one of the 3-digit codes listed for your device.
If you are programming a code into AUX mode, you need to enter an additional digit before the actual device code.
Step 3: Release the pound button.The mode button will blink if the code is valid.
The code can be tested by pressing the "Power" button.If the device is turned off, try some other buttons to make sure they work, as sometimes the "Power" button may not work when others don't.If the procedure doesn't work, use another code from the code tables.
If a device is not listed in the code tables or if the listed codes don't work, you can look through all the codes until you find one that controls your equipment.
Press and hold the mode button for 3 seconds until all the other mode buttons come on.
The number buttons can be used to enter a number for a second TV, a VCR, and an audio tuner/ amplifier or cable box.Press the Star button.
One press per second is enough to turn off your device.The "UP ARROW" button scans forward, while the "down arrow"button scans backwards.The Mode button is on when all codes have been tried.
The device will turn off when the remote reaches the correct code.If this happens, you can store the code by pressing the pound button.The matching mode light blinks three times.
The device can be turned back on by pressing the "Power" button.If you find the right code, try some other remote control buttons.
The mode button needs to be held for about 3 seconds.The mode button should be released when the other mode buttons come on.