Dog houses are a worthwhile investment, whether you have an outdoor or indoor dog.A dog house can be used as a permanent shelter for outdoor dogs, or a place for indoor dogs to hangout.The building of a dog house is not easy.You have to design the dog house and cut the wood to make it.With a little bit of time and knowledge, you can build a dog house.
Step 1: Determine the length and width of the dog house.
Some people want to build a jumbo dog house for their dog, while others want a smaller house.Do you want a big dog house?The minimum size of your dog house needs to be measured.Make it bigger than your dog.Your dog's height should be at least half a foot higher.You should make your entrance half a foot wider than your dog.Try to round the measurement of your house to the nearest half foot.Measure and buy materials will be helped by this.
Step 2: The dog house should be sketched.
You need to sketch the dog house before you can start building it.You can start the construction process with confidence if you sketch your doghouse.One inch is enough to represent a foot.To represent half a foot, use half an inch.This should be easy since you rounded to the nearest half foot.All four sides of your dog house have a measured value.All four sides of the dog house have a measured value.The entrance should have a measured value.From the top looking down, sketch the roof outline for each face.The measured value should be included for all sides.Make sure your frame is labeled and has a measured value.Make sure the piece of siding that goes over the frame has a value.
Step 3: In your yard, pick a good spot.
Once the doghouse is built, you need to place it in your yard.Picking a safe and convenient spot is important as your dog will likely be spending a lot of time there.Pick a spot that is close to the house.If you need to feed or check on your dog, you might want it to be close.The shape of the ground.Pick a spot that is high and flat.Water pooling around the dog house is not something you want.There is an area with shade.The dog house should be in a shaded area if you will be out during the summer.If the sun doesn't shine on its roof, it will heat up your poor pup.
Step 4: Your dog house will be on the ground.
You need to get the ground ready for your dog house.You will need to remove any grass or organic material.The floor of your dog house is going to be the ground on which it sits.If you want to dig up the grass or plants, use a shovel.If there are any holes that need to be filled, get some soil from a nearby store.The backside of a rack can be used to flatten the soil.
Step 5: Get all of the appropriate tools.
There are many tools you will need to build a simple dog house.Before you start any part of your construction, make sure you get all of them.If you don't you'll have to stop construction and run over the neighbor's house or hardware storeYou will need a saw.You can use a table saw or hand saw.A tool.An electric drill.A paintbrush.There are small roofing tacks.2-inch screws, and 1-inch nails.
Step 6: Buy something that is made out of wood.
You will need a decent amount of wood to build your dog house.The amount of wood depends on the size of the house.You need to buy enough wood.You should consider buying at least 10% more wood.Extra material will be provided if you make any mistakes or additions.Buy 2x4s for the frame.The siding of the dog house can be purchased with plywood.If you plan to store the house outdoors, use waterproof wood.If this works for you, you should pre-cut your wood at the store.
Step 7: Purchase roofing material when you decide to do so.
You need to decide on roofing material as well as plywood and 2x4s.It's important that your dog house is protected from rain and snow because it prolongs the life of your creation.Consider 3-tab roofing tiles.Old roofing supplies from previous projects are free to use.You can put tar paper, felt, or other roofing paper underneath the tiles.
Step 8: Pick a color.
You have to buy some paint.Painting your dog house will help protect it from the elements and it will add a measure of style to your new creation.It's a good idea to consider a color that matches your house.One gallon of exterior paint is fine for most projects.Don't paint the interior.Only use exterior paint if you want to measure the weather.Extra paint can be used if you have some leftover from another project.
Step 9: Unless you pre-cut it at the store, cut it yourself.
The first thing you need to do when building a dog house is cut all of the wood you will need for construction.When you start the construction process, it is important to have all of your materials ready to go.Remember that you used one inch to represent one foot on your sketch, and make sure to cut with precision.To make your base, cut 2x4s.You should have two long and two short base pieces.Use 2x4s for your framing.Four corner posts will be included in your framing.Four pieces will be used as the top of the frame, which will match the dimensions of your base pieces.Extra support frames can be added to your dog house.To make your siding stronger, cut plywood.
Step 10: Attach the base to the building.
Attach the four base pieces and the bottom plywood piece to each other.Make sure to do it correctly because the base will create the foundation of the house.The 2 inch sides are on the ground if the 2x4s are turned up.Make sure you are working on a level surface.Attach one short piece and one long piece to the wood using an electric drill and screw a two inch nail into it.Attach the short 2x4 to the opposite side of the L shaped foundation.Take your final piece and screw a 1.5 inch screw into the corner of the rectangle.Make sure the side pieces are at the right angle by using a square.
Step 11: The rest of the frame needs to be finished.
You need to consult your sketch and complete the frame of the dog house after you have the base together.You need to be careful since the frame is the most important.Attach the corner posts to the base with an electric drill.The long face of the 2x4s should be parallel to the dog house.If you have extra 2x4s, place them close to the corner posts on the long side of the dog house.The four pieces that were measured were the same as the base.Attach them to the corner posts with an electric drill.Make sure to use two inch screws to screw them into each other.Make sure the side pieces are at the right angle by using a square.
Step 12: It's time to build the roof.
You need to frame the roof after you framed the house.Make sure to follow your sketch of your roof frame and shape.Make sure to frame your "A" shape well, if you chose a gable roof that has two sides that slope and a triangle-shaped wall at each end.Attach 1.5 inch screws to your roof frame with an electric drill.Attach the roof frame to the main frame with 1.5 inch screws.You can move on to the next step if you choose a flat roof.
Step 13: Attach the plywood to the roof frame of the dog house.
It is time to attach the plywood siding to the dog house after you have framed the roof.The walls of your dog house will be created by your plywood siding.Attach the pre-measured plywood to the long sides of the dog house.Hammer the nails into the frame.3 nails are used for each corner post.To secure the plywood to the base, use 2 sets of 3 nails.If you used an extra piece of 2x4 for support, use 3 more nails to secure the plywood to it.Attach the plywood to the short sides of the dog house.The dog house door should have special wood cut from your sketch.3 1-inch nails are used to secure the plywood into the corner post.Attach your pre-measured plywood to the main frame of the dog house if you chose a flat roof.
Step 14: Take care of your roofing material.
It is time to attach your roofing material after you secured the plywood to the frame.You will want to protect the dog house from rain and snow by attaching your roofing material.If you put tar paper under the shingles, put it down.Attach the paper with 12 inch tacks or nails.The dog house has a roof.Attach the 3-tab with 12 inch tacks or nails.
Step 15: The dog house can be painted.
It should be painted with your choice of paint.Paint will help preserve it.It will make your yard look better.Take your paint brush and apply a thin coat of paint to the dog house.Apply a second coat of paint after the first has dried.You can paint the dog house upside down if you want.The wood may be able to stand up to the elements longer.
Step 16: Take a look at the dog house.
It will be time to inspect the dog house after you finish the roof and paint it.It is important to inspect the dog house to make sure it is safe for your dog.The dog house needs to be inspected thoroughly.Look for nails or screws that are not straight.Pay special attention to the nails that are coming through the roof.Attach each piece of the dog house to the frame.The test is a soft shake.You can Rattle the dog house to see how stable it is.This will give you an idea of how it will hold up.