James Hardie Building Products recommends keeping nails or screws at least 3/8 inch from the end of a plank. ... Drill pilot holes, at each mark, one-quarter to one-half inch deep, to make it easier to insert screws and prevent cracking the siding. Align the bracket holes with the pilot holes in the siding.
How do you drill into Hardiplank siding?
It can be cut and drilled just like wood. However, drilling through cement-fiber siding goes better if you use a carbide drill bit, as opposed to a regular steel drill bit. Cement-fiber siding can be drilled while installed on a house or prior to installation.
How do you hang things on Hardie board siding?
Our Answer. The best way to attach to Hardie Plank siding is by using nails or screws. To avoid cracking the siding, pilot drill the siding first, using drill bit a little smaller than the nail or screw. And to make the sure the hole you are forming doesn't leak, caulk the hole before driving in the fastener.
Will Hardie board hold a screw?
What type of fastener do you recommend for floor and wall applications of HardieBacker® cement board? In compliance with the tile industry, James Hardie recommends 1-1/4'' long galvanized or stainless steel roofing nails (0.121'' shank x 3/8'' HD) or 1-1/4'' long corrosion resistant ribbed waferhead screws (No.
Can you drill into Hardiplank siding?
HardiePlank is available as ready-to-paint or with a color layer. Although the siding does not require drilling pilot holes, you may need to run wire or cable through the siding, necessitating drilling a hole.
Can you screw into Hardie backer board?
Use the fastener pattern as a guide. Fasten HardieBacker cement board with specified nails or screws (as listed in “Materials Required") every 8 in over the entire surface. Keep fasteners between 3/8 in and 3/4 in from board edges and 2 in from board corners.