Can you use a joint compound on a hardibacker?
If the tile does not cover the joint between the cement board and the drywall, don't worry.You can finish it with a 25-lb. setting-type joint compound.You mix the bags of powder with water.
Can you use joint compound on durock?A seal between the Durock panels and to fill the depressions left by either nails or screws is provided by a joint compound.Durock can be painted smooth with proper finishing.
Mud should adhere well to hardiboard because it has more texture than sheetrock and is more absorbent.The flex of Hardiboard is less than sheetrock, so there should be no issues with cracking of dried mud.
Thinset will stick to the mud.Make sure you don't leave a hump at the seam, and try to position the tile so it runs near the middle, but not under a grout line.The mud will want to pull the water out of the thinset if it starts drying too quickly.
There are 2 answers.The thinset and mesh tape are used to strengthen the seams.You should tape the seams if you are going to tile over the cement board.That seam won't split the center of the tile, so if you just want to leave the corners untreated that will be fine.
You can use plaster to prime the surface.It's a primer that gives you a base.Use a brown bag durabond with plaster of Paris to skim the area.You want it to dry quickly so you can apply the next coat.
Thanks!It's fine if you don't rip it out.Sand it and then paint it.
The joint between cement board and greenboard is the same as the one between two pieces of drywall.If possible, plan the installation so the cement board and greenboard overlap the last column of tiles.The bag has instructions on how to mix mortar.
There is no need for a cement board under the tub.A sturdy layer of ply under the tub is more important.
A mortar is a mixture of lime with cement, sand, and water.Thinset is also sometimes referred to as a "mortar".It's made of cement, water, and sand.
The backer board is 1/2-inch or 5/8-inch thick.Apply directly to the wall studs or joists, with each spacing at a maximum of 16 inches on-center.
Is it possible to use cement board tape on regular drywall?No.Cement board tape is embedded in thin-set mortar.We don't think it's a good idea to use it on regular drywall.
Not likely.The installation instructions for the backer board say it can be finished with paint.The backer board can be used on the tiled part.It's used in every bathroom.
Dust and debris from the Durock panels can be wiped with tape.If you cut fiberglass mesh tape to fit in a single layer over every joint, it won't overlap the tape.A clean plastic bucket is used to mix powdered latex-reinforced cement mortar with water.
The first step is to clean the area.If you want to paint the cement surface, you need to clean it thoroughly.The area should be let to dry.Make sure the board is completely dry before you start painting.The third step is to prime the board.The fourth step is to apply the paint.The next step is to apply the Sealant.