It is simple to maintain stamped concrete.For regular maintenance of a concrete stamped surface, sweeping and wet mopping with water is sufficient.You can use a mild detergent to wash the surface.Make sure you don't use harsh chemical cleaners on the stamped concrete.
Step 1: The surface needs to be cleaned.
The first step in cleaning a stamped concrete surface is removing dirt from the surface.The broom can be used to remove debris from the concrete.If it is outside, you can use a leaf blower.
Step 2: The surface was wet.
A weekly wet mopping is usually enough for regular cleaning of stamped concrete surfaces.After sweeping the floor, dip a rope or foam mop into a bucket of warm water.Thoroughly clean the floor.You should change the mopping water when it becomes dirty.
Step 3: It's possible to try mild detergent.
Adding a nonabrasive cleanser to your mopping water can help clean your stamped concrete surface.A few drops of dish soap, laundry detergent, or other mild detergent is enough to create an effective cleaning solution.Chemical-based cleaners can dull the surface.
Step 4: Pressure washing outdoor surfaces is a good idea.
You can use a pressure washer to remove tough stains from a stamped concrete surface if water and mild detergent are not effective.There are tire marks, leaf stains, and grease spots that can be removed with pressure washing.You can rent a pressure washer at the hardware store.
Step 5: An alkaline degreaser can be used to remove oil, grease, and soot.
Oil and grease can be removed from the surface of stamped concrete with an alkaline degreaser.The degreaser can be used with hot water.Follow the directions on the degreaser label.
Step 6: To remove rust, use oxalic acid.
If your concrete has a rust stain, you can use a cleaner with oxalic acid to remove it.Before using oxalic acid, make sure you consult the company that manufactured the concrete.
Step 7: Dust is swept and mopped weekly.
It is important to keep a stamped concrete surface free of dirt, leaves, and other debris after you clean it.To remove debris weekly, use a broom, leaf blower, or garden hose.
Step 8: It's a good idea to seal the surface every few years.
The color and sheen of your concrete surface can be protected.To block dirt, dust, and stains, apply a seal to the concrete surfaces every few years.Talk to the contractor that installed the stamped concrete to find out what is best for your surface.
Step 9: The high traffic areas should be polished.
There are signs of wear on the stamped concrete surface of high traffic indoor areas.Use a floor polish or wax on the surface for extra protection if this is the case.The polish should be formulated for stamped concrete.
Step 10: Don't use deicing salts and chemicals.
If you don't use harsh agents to remove snow and ice, your stamped concrete surface will last longer.Over time, these substances can affect the stamped concrete surface.