PREMIUM UNIVERSAL JOINTS FOR PASSENGER CAR AND LIGHT TRUCKS MOOG ® Premium u-joints bearing cups are cold-forged and case-hardened. Their radial design allows 360˚ lubricant distribution to all bearing surfaces, while the steel cross incorporates a grease fitting for easy maintenance.
Who makes the strongest universal joint?
Moog U Joint With over 100 years of experience, Moog today stands as of the most reliable u joint supplier in the market.
Who makes precision universal joints?
Precision, a brand that is owned and controlled by Federal-Mogul, is a world-renowned supplier of U-joints and differential bearings.
Do MOOG U-joints need to be greased?
NOTE: The u-joint must be greased prior to installation. There is only enough grease in a new MOOG u-joint to keep the needles in place during assembly, which is not sufficient for operational lubrication.
How do I know what size U joint I need?
You measure from the outer side of the lock ring groove side to side. This gives you the width of the joint lock. You still need to measure the overall width of the joint to make sure it is compatible with the bolt-on yoke.Mar 16, 2017
What is the difference between a 1310 and 1350 U joint?
Size and strength. The 1310 series joint is what you would expect to find stock in most Jeep or small trucks. A 1350 series joint/shaft is what you might find in many full size trucks. While it's not 100% accurate, you could say that a 1310 is a "half ton" joint and a 1350 is a "one ton joint".
What is the difference between 1330 and 1350 U joint?
U-joint sizes are classified by a series number. Each series has a very specific cap diameter and overall joint width. ... The 1330 to 1350 U Joint cross width is 3.625 (3 5/8”) on both sides, while the cap diameters are different. 1 1/16″ on the 1330 side and 1 3/16″ on the 1350 side.
What is the difference between a 1350 and 1410 U joint?
1350 joints are found in 1-ton trucks and use the wider body of the 1330 joint but with larger trunnions and caps. 1410 joints use a wider body but the same-size caps as a 1350 joint, making them perfect for high-horsepower, high-angle applications. ... The two joints split the angle, allowing for greater angularity.Jun 1, 2013
What is the most common U joint?
For most cars, 1310-series U-joints are typical choice, but for performance applications, the rugged 1350-series joints are the better choice.Mar 16, 2017
Is the most common type of drive shaft U joint?
cross and roller
What series is a 331 U joint?
Product description This is a NEW 1350 Series replacement Universal Joint that fits a variety of 1957-2015 General Trucks and some Corvette rear axle shafts.
How are U joint series determined?
U-Joint Sizes The width of the joint is measured across the ends of the caps as shown for outside locks. Inner lock type joints should be measured from the outer side of the lock groove.Mar 16, 2017
What is a 3R U joint?
This u-joint is a conversion u-joint. One side of the cross is standard 1310 series. The other side of the cross is the larger and wider 3R series. The 1310 has external clips while the 3R has internal clips. 1310/GM 3R Combination Universal Joint.