How close must a fire alarm manual pull station be located next to an exit door?
How close must a fire alarm manual pull station be located next to an exit door?
NFPA 72 requires that manual pull stations be installed within 60 inches of the exit doorway of each exit, mounted between 42 inches and 48 inches to the center of the handle, and, among other things, be red in color.Jun 27, 2018
What is the height of a fire alarm pull station?
Manual Fire Alarm Boxes (Pull Stations) – The height of the manual fire alarm boxes shall be a minimum of 42 inches and a maximum of 54 inches measured vertically, from the floor level to the activating handle or lever of the box. Manual fire alarm boxes shall be red in color.
What is the maximum distance that a manual alarm box can be located from an entrance to an exit?
5 feet
Why is there a key slot located in some fire alarm pull stations?
Fire alarm pull station. ... After operation, most fire alarm pull stations must be restored to the ready position using a special tool or key in order for the panel to be reset.
How do I reset my manual pull station?
https://www.youtube.com/watch?v=X18pSLhehKQ
How do you reset a pull station without a key?
https://www.youtube.com/watch?v=aAzqt8tzDs0
How do you activate a pull station?
Single-action pull stations are simple in their design — they are fitted in a wall without any coverings or special activation mechanisms. These pull stations are activated by pulling the handle down.Nov 30, 2020
How do I reset my fire Lite pull station?
Resetting the Pull Station Insert the key into the lock and rotate 1/4-turn counterclockwise. 2. Open the door until the handle returns to normal.
How much does a fire alarm pull cost?
On average, fire alarm equipment is usually priced at $1 to $2 per square foot, but the price can go up to $3 to $6 per square foot depending on how complex the installation is. In addition, the older the building, the more expensive your installation will be.
Are pull station addressable?
Addressable manual pull stations are a single action or dual action addressable manual fire alarm pull stations for use with IntelliKnight® fire control panels. Extremely easy to operate, the addressable manual pull stations provide a fast and practical means of manually initiating a fire alarm signal.
What is a local pull station alarm?
Good question! Pull stations are those little red things along walls in buildings, malls and condominium complexes. ... If a pull station is marked “Local Alarm Only,” it will make noise and lights may flash to alert people in the building that something is wrong, but you're still going to need to dial 911.
What is a fire pull switch?
A fire alarm pull station is an active fire protection device, usually wall-mounted, that, when activated, initiates an alarm on a fire alarm system. ... After operation, most fire alarm pull stations must be restored to the ready position using a special tool or key in order for the panel to be reset.
What happens when a fire alarm pull station is activated?
Pull stations send a signal to the control panel, and if the fire alarm is monitored, the control panel then usually sends a message to a company's monitoring service, which transmits that message to first responders. In some cases, a signal is transmitted directly to a fire department.Aug 22, 2018
What does a pull station do?
A fire alarm pull station is an active fire protection device, usually wall-mounted, that, when activated, initiates an alarm on a fire alarm system.