To adjust the thermostat, you simply press the button that increases or decreases the water's temperature. Some hot tubs may use a mechanical thermostat to control the water temperature and you need access to the spa's heater to adjust this thermostat.
What is spa mode on hot tub?
ECONOMY mode heats the spa water during filter cycles only. For example if your spa is set for 100 degrees it will heat until the water temperature reaches 100 as long as the filter cycle is running.
How do you adjust the temperature on a master spa hot tub?
First let's focus on the temperature control your hot tub or swim spa is factory preset at 100 degrees, but if you want to increase the temperature just press the up arrow if you want to decrease the temperature just press the down arrow.
What do the buttons on my hot tub mean?
Some larger hot tubs may have up to three jet buttons on the control panel that allow you to adjust the speed and strength of your jets. In most cases, pushing the button the first time will turn them on a low setting and pushing it again will increase the speed.
How do spa controls work?
The control keypad on top of the spa allows communication with the control pack. When any issues arise, Error Codes will display. Non-digital air systems have buttons that send a puff of air to switches, turning each function on or off.
What is the control panel on a hot tub?
The control system, or spa pack, is the brain of the hot tub. This nerve center controls the functions and equipment in the spa, like the jet pumps, filtration time, and heater. There are two types of control systems used in hot tubs: electronic, digital type systems and older-style mechanical air controls.
What mode should my hot tub be in?
Economy is a good setting for those who use the hot tub daily. The drop in temperature fluctuates during the year from minor or no temperature falls in the summer, to larger drops in the coldest part of winter.
How do I reset the control panel in my hot tub?
https://www.youtube.com/watch?v=xK3P0fXZQfA
Is there a reset button on hot tub?
There are generally two "hard resets" in hot tubs, the GFCI, and the high limit reset. The GFCI pops if there is any type of electrical short (such as water getting into the heating element, the reset on that can be in one of three places.
Where is the reset button on a hot tub pump?
https://www.youtube.com/watch?v=OwhFwZYtVf0
Why is my hot tub control panel not working?
Bottom line is - it could be a bad spaside control panel, or it could be a bad spa control board, or a bad cable that runs between the control panel and the control board. Or it could be fuse on the circuit board or the transformer, not sending the correct power to the topside panel.
How do I know if my control panel is bad in my hot tub?
- Error messages or error codes may indicate the problem.
- Flickering display may indicate low voltage from transformer.
- Partial display may indicate dirty contacts or moisture.
- Blinking lights or flashing --- indicates a system reset is needed.
How long does a hot tub control panel last?
That said, most topside spa panels will last 10 years. If you have had repeated and mysterious failures to the pcb every few years, it may be a good time to replace the entire spa pack. New spa packs are less prone to circuitry problems. If your spa pack and control is over 20 years old - it's a good time to upgrade!