- Power the dryer OFF and unplug it from the electrical outlet (You can also trip the circuit breaker if that's easier).
- Press and hold the START/PAUSE key for 5 seconds while the unit is without power.
- Turn the breaker back on, and power on the unit.
How do you reset the flow sensor on a LG dryer?
- Unplug the dryer or trip the circuit breaker supplying power to the dryer off.
- While the dryer is without power, press and hold the Start/Pause button for 5 sec.
- Restore power and try to run a cycle.
What does D80 flow sense mean on dryer?
The d80 error means the dryer is 80% clogged either in the air exhaust hose, wall ducts, or the vent outside. ... – Check the wall duct to be sure there is not a large lint blockage in the wall and preventing airflow. – Check the outside vent to be sure lint has not built up to the point that air cannot flow properly.
How do I check the flow cycle on my LG dryer?
Press and hold the Temperature Control and Signal button simultaneously, and then press the Power button. Once the display shows In5, press the Start/Pause button. The dryer will start the test which will run for approximately 2 to 3 minutes. Do not interrupt the test cycle as this could result in the wrong result.Oct 12, 2018
Why is my dryer flashing flow sense?
The FLOW SENSE™ duct blockage sensing system detects and alerts you to restrictions in the installed household ductwork that reduce exhaust airflow through the dryer. If you see the alert: Clean or repair the ducts to remove the restrictions.