How do I get the lint trap out of my Whirlpool dryer?
How do I get the lint trap out of my Whirlpool dryer?
- Roll lint off the screen with your fingers.
- Wet both sides of the lint screen with hot water.
- Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.
- Rinse screen with hot water.
- Thoroughly dry the lint screen with a clean towel.
How do you open a lint trap on a Whirlpool dryer?
https://www.youtube.com/watch?v=yaqd109RQxQ
How do I clean the lint from my Whirlpool front load dryer?
Using a vacuum crevice tool or dryer cleaning brush, carefully clean the interior and exterior of the lint trap, as well as the moisture sensor strips on the outside of the lint trap. When you're done, make sure to replace the lint screen, close the door and plug your dryer back in.
Where is the lint trap in a dryer?
Typically it's located right inside the dryer's door or on top of the dryer. The lint trap is used to catch the majority of the lint from your laundry before it gets into your dryer vent. The lint trap should be cleaned out after each dryer use.
How do I clean the lint out of my front load dryer?
- Remove lint screen from the dryer and wash in warm soapy water (see notes below)
- Use a screwdriver to remove the "cover" from the lint filter compartment and thoroughly clean with vacuum and microfiber cloth.
- Use a lint vent cleaning brush to loosen lint and debris inside the dryer.
Where is the lint trap on Whirlpool dryer?
Each Whirlpool dryer is equipped with a lint trap located inside on the rear wall of the dryer. The lint that accumulates in these traps should be removed each time the dryer is operated.
How do you clean a Whirlpool front load dryer vent?