How do I know if my rechargeable liquid is working?

Step 1 is backflushing the soap feed.I learned how to clear soap blocks if they aren't too big.There are 3 screws that need to be removed.The bottom needs to be removed.The Pully and the Pump have to be removed.The Electronic Board needs to be removed.The tube needs to be cleaned.The next step is at the pump.The pump needs to be reassembled.

How do you fix an automatic soap dispensers?The unit needs to be turned off.To empty the tank, open the lid.Take the tank out and empty it.Clean the nozzle.The unit should be turned on.The sensor should be used to get the soap out of the line.The water should be added to the tank to rinse the particles.

Hold down the "+" button until soap comes out.The amount can be adjusted by pressing the "+/-" buttons.It's all automatic after that, as in "place hand underneath - get soap."If the soap doesn't flow, lightly flick the valve opening to release any trapped air.

The sensor pump can fully charge in two hours and provide up to three months of regular use, if you use a power adaptor.