Common solutions for: My Washing Machine Lid Won't Lock If the door lock is defective, the washer door will not latch properly. The door lock can fail either mechanically or electrically. Inspect the door lock for damage. If the door lock is damaged or does not latch properly, replace it.
Where is the control lock button on Whirlpool washer?
- Locate the "Control Lock/Unlock" button on your Duet's control panel. ...
- Press and hold the "Control Lock/Unlock" button for three seconds.
- Release the "Control Lock/Unlock" button when the control lock icon on the display disappears.
How do you install a lock washer?
Place the lock washer under the threaded fastener and ensure that it has a snug fit. If using a lock washer with teeth, make sure they will engage with the appropriate surfaces. If they don't, swap out the washer for the appropriate one. Turn the fastener with a ratchet or wrench until it tightens to a firm connection.
Do you put lock washers on both sides?
The washer helps prevent damage to the surface of the object being fastened. In most cases where the bolt is easier to turn, the bolt has a round head that will cause less damage anyway. For the same reason, lock washers always go on the nut side to stop the nut moving.
How do nut washers work?
Split ring washers use friction to prevent bolted joints from loosening. They feature a ring that has been split and twisted - creating two sharp edges. ... When the nut is tightened, the washer flattens down, pushing the sharp edges into the mating surface.
What order do lock washers go on?
When used correctly, a lock washer will hold the nut or other threaded fastener in place. To help it accomplish this, put the lock washer on first, below the fastener. If your project calls for other washers or hardware elements, they should go on before the lock washer so that it can hold them in place.
How do you use a lock nut washer?
https://www.youtube.com/watch?v=p44lFxdAj2U
Do lock washers actually do anything?
They are still used on many applications in the belief that they will will "lock" the nut/bolt to the joint and prevent loosening. The body of evidence, based upon both experience and experimental results, is that they do not prevent loosening and can be shown to actually speed up the rate of loosening in many cases.
Do you really need lock washers?
When are lock washers needed? Lock washers are needed when the fastener assembly is subject to vibration or wherever back off is considered an issue. When should I use washers with bolts? Always use a washer between the installation material and the nut.