- Unplug the transformer from the power source.
- Disconnect the battery.
- Plug the transformer back in.
- Reconnect the battery.
- Within 30 seconds of turning the alarm system on, press * and # at the same time. ...
- Enter *20.
- Enter a new 4 digit installer code. ...
- Press *99 to exit programming mode.
How do I program Vista 21iP?
- Enter Programming. ...
- Enter Zone Programming. ...
- Enter the zone number to be programmed. ...
- Skip the summary screen. ...
- Enter the appropriate Zone Type. ...
- Enter the appropriate partition number. ...
- Enter a Report Code. ...
- Enter the Input Type.
How do I change master code on Vista 21iP?
https://www.youtube.com/watch?v=eJec11AcpS4
How do I program a vista 20P?
To enter programming on a VISTA-20P alarm control panel, you can either enter your 4-digit installer code followed by [800] or, if you don't know your installer code, you can power the VISTA-20P down (remove battery backup and transformer) and then press [*] and [#] together within (50) seconds of powering back up.Nov 6, 2012
How do you program a Honeywell wireless door sensor?
- Access system programming. Enter the installer code (the default code is 4112) + 800 on a keypad. ...
- Access zone programming. Enter * 56. ...
- Select a zone. ...
- Program the zone. ...
- Exit programming. ...
- Test the sensor.
How do I reprogram my Honeywell keypad?
- Press 8 (the CODE key).
- Press 02.
- Enter a new four-digit master code.
- Re-enter the new code. The keypad will beep once to let you know that the code has been changed.
How do you address a 6160 keypad?
To address the Honeywell 6160 keypad, power up the keypad and within 60 seconds, press and hold down the numbers 1 and 3. The 6160 keypad will not enter address mode if the control panel is in programming mode.Mar 17, 2015