If your fan is a Hampton Bay fan, then you would get a Hampton Bay remote in order to replace the existing one, or a Universal remote. These very same universal remotes will also work with other ceiling fan brands as well, but will have the best compatibility with other Hampton Bay fans.
Are all ceiling fans remote compatible?
While most ceiling fans are remote control adaptable, meaning a remote can be added if desired, there are some of fans that come with a remote and cannot have a switch installed (i.e. remote only). Majority of fans include a wall switch (3 speed dial) that can be fitted into any standard switch plate.
Are ceiling fan remotes universal?
There are many “universal” ceiling fan remote control kits on the market for overhead fans controlled by pull chains and a singe wall switch. All of them feature on/off and fan speed control. But whether you can use a ceiling fan remote kit depends on the amount of free space inside the fan canopy.
How do you pair a Hampton Bay ceiling fan remote?
To begin, turn the remote over to the back and press firmly below the arrow on the battery cover. Slide the cover off and install a 9-volt battery into the compartment. Set each slide code switch near the battery into a position of your choice. Switches can be up or down, with up to 16 available combinations.
How do I reset my Hampton Bay ceiling fan remote?
Reset your remote control. First, turn off the power. Then remove the batteries from the remote and wait 10 seconds. Replace the batteries and turn the power back on.
How do I resync my ceiling fan remote?
There are several ways to reset a ceiling fan remote, but here's the most straightforward: With the power off, hold down the button until the light on the remote flashes. Then, press and hold it again for 15-30 seconds to resynchronize the remote with your fan.
Where is remote code on Hampton Bay fan?
Hampton Bay Ceiling Fan Receiver Location: If your transmitter has a reverse button, then the receiver will often usually be in the Switch Housing (located between the blades and the light kit). Sometimes you will find it around the top of the motor, on the side of the motor, or in the canopy, at the ceiling.
Why is my ceiling fan not responding to the remote?
Perhaps the most common cause for a ceiling fan remotes not working is either a lack of batteries or dead batteries. If it doesn't, that's a good sign that it has a battery problem. Open the remote control battery cover. Make sure it has batteries and that they're in the correct position.
Why is my remote not working?
A remote control that will not respond or control your TV usually means low batteries. Make sure you are pointing the remote at the TV. There also may be something interfering with the signal such as other electronics, certain types of lighting, or something blocking the TV remote sensor.
How do I reconnect my ceiling fan remote?
Turn the power to your fan off for 5-10 seconds and then back on using the wall switch. Quickly press the 'PAIR' button on the back of the remote control. This step should be done within three minutes of restoring power to the fan. Your fan should turn on low speed indicating the pairing was successful.