Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.
How do you troubleshoot a Whirlpool Cabrio washer?
Clean all contact areas on the lid and the washer. Try unplugging the washer to allow the control panel to reset. Plug the washer back in and see if the problem resolves. If the door sounds like it is engaging, but doesn't, it is time to run a diagnostic test.Dec 12, 2019
Is there a way to reset a whirlpool washer?
Method 1: Unplug it The first way you can reset whirlpool washer top load is by unplugging it for about 2 minutes then plug it back in and wait about 30 seconds before starting the washer again. This performs a hard reset on the machine and it will start over after you reconnect it again.
How do I reset my whirlpool washer?
Method 1: Unplug it The first way you can reset whirlpool washer top load is by unplugging it for about 2 minutes then plug it back in and wait about 30 seconds before starting the washer again. This performs a hard reset on the machine and it will start over after you reconnect it again.
How do you put a Cabrio washer in diagnostic mode?
https://www.youtube.com/watch?v=yoCTzbl4FPs
How do you reset a Whirlpool Cabrio?
Press the Start Stop button once. Rotate the dial until Rinse, Wash, and Stop light illuminate. Turn the washer off and unplug it for 10 seconds. Finally, turn on the washer and it should now be reset.Sep 10, 2015
Why is my Cabrio washer not working?
This is usually caused by a clog in the drain line or something obstructing the pump. Clean out any lint or obstruction (coin, small button) that is clogging the pump filter. Turn off the water connections. ... If these steps don't solve the problem, the washer's water pump may need to be replaced.Dec 12, 2019
How do you reset the touchscreen on a Cabrio washing machine?
- Press PAUSE/CANCEL twice to cancel the cycle. The washer will drain.
- Press POWER.
- Select the desired wash cycle.
- Select the desired Modifiers and Options.
- Press START.
What is a Cabrio reset?
If your washer is still not working correctly, you can try the Cabrio reset procedure. Touch any button that you see on your display pad. This will clear the error code. Or you can press PAUSE/CANCEL. ... Then disconnect the Cabrio from power if you see the issue or error come back.
How do you reset the code on a Whirlpool Cabrio?
Touch any button on the display pad to clear the error code or press “Pause Cancel.” Choose another cycle and press “Start”. Disconnect the Cabrio from power if the error or problem comes back. Wait 5 minutes before restoring power.Sep 10, 2015