Open eero's mobile app. Go to dashboard.eero.com and follow instructions to log in. Once you log into the Remote Network Management account, complete the transfer of each network to your dashboard by selecting Finish setup in Pending Networks section.
How do I reset my eero to factory settings?
To hard reset your eero, hold the reset button until the LED flashes red (15 seconds), then release it. After a successful hard reset, the eero LED light will reach a flashing blue state, indicating that the eero is ready to be set up again.
How do I delete my eero account?
Tap on the eero and tap on Remove eero at the bottom of the next screen. You can also delete your network by choosing Network Settings in your eero app. Tap Advanced settings and tap on Delete your network.
What is the second Ethernet port on eero for?
Each eero has two Ethernet ports. The other Ethernet port can be used to hardwire another device (such as a Sonos player) directly to your network. If you're using more than one eero, you can also use the Ethernet ports to wire eeros together.
What is the button on Eero beacon?
The eero Beacon reset button can be found on the left side and the same instructions below apply. Before resetting your eero, make sure it has been powered on for at least 45 seconds. You can use the reset button to perform two distinct actions: a soft reset and a hard reset.
How do I transfer my eero to a new owner?
To do this, hold down the reset button on the back of the eero until the LED light turns red. After that, give it a few moments and it should start flashing blue, signaling that it's ready to be added to a new network. I hope this helps!