- Open the door/cover over the pilot light access. ...
- Use a flashlight or a headlamp to find the burner inside. ...
- Turn the gas knob to “Pilot,” press and hold it down. ...
- While still holding the gas down, light that pilot.
How do you restart a gas water heater?
https://www.youtube.com/watch?v=05ucgUqUD1k
What do you do if your pilot light won't light?
If your pilot light won't stay alight, it might be the thermocouple. Sometimes dust buildup collects on the thermocouple and blocks the sensor. Try cleaning the thermocouple and then relighting the pilot light. If it continues to go out, the thermocouple might need to be replaced.Jan 27, 2020
How do I turn my pilot light back on?
- Find the pilot light assembly and its reset switch. The furnace's pilot light is usually positioned at the bottom of the unit by a knob. ...
- Set the reset switch to off. Turn the knob to the “Off” setting. ...
- Wait a moment. ...
- Relight the pilot light. ...
- Observe the furnace.
How do you reset the pilot light on a furnace?
- Step 1: Turn off your furnace. ...
- Step 2: Locate your gas valve. ...
- Step 3: Hold down the red button. ...
- Step 4: Light the pilot light. ...
- Step 5: Let go of the button. ...
- Step 6: Turn your gas back on. ...
- Step 7: Turn your furnace back on.
How do you light a pilot light on a boiler?
Turn the gas control knob to the "pilot" position, then press down on the knob. Pressing down on the knob will release gas into the pilot light orifice. Insert a lit fireplace match or a butane candle lighter into the access hole and light the pilot light. Keep holding down the control knob button as you do this.
How do I know if my pilot light is on?
If your pilot light is on, it should be easy to see – your eyes will be drawn to the little flame. If you don't see a flame, your pilot light is out. If there is a flame, check the color. Pilot lights should always be blue.
What does a pilot light look like when lit?
Inspecting a Gas Furnace Pilot Light Flame A natural gas flame should be a bright blue color with a small amount of yellow at the very tip. A propane flame will have more of a bluish-green flame with a tinge of yellow at the tip. The flame should strong enough to cover about 1/2 inch at the end of the thermocouple tip.Jan 10, 2018
What does a blinking red light mean on a water heater?
Because there is air in the gas line, it may take up to 90 seconds before the red status light begins to blink. The red status light will blink once every 3 seconds when the water heater is operating normally.
Where is gas water heater reset button?
A water heater reset button, usually red, is located in the center of the limit switch just above the water heater thermostat. The water heater limit switch is a safety device that will shut the power down to the water heater if something malfunctions and the water gets to hot.