After opening your machine, you should see the ice thickness sensor attached by a single screw. Adjust this screw one quarter-turn counterclockwise for a smaller bridge and thinner ice. Adjust this screw one quarter-turn clockwise for a bigger bridge and thicker ice.
How do you adjust the thickness of ice probe?
1. Turn adjustment screw (Figure 4) on ice thickness probe clockwise to increase ice thickness, counterclockwise to decrease ice thickness. 2. Ensure ice thickness probe wires and bracket do not restrict movement of probe.
How do I adjust my ice maker?
https://www.youtube.com/watch?v=UUCdhFdl2eA
How do you adjust the ice thickness on Koolaire?
Use the wrench on the float switch located on the left, as you are facing the front of the machine, to loosen or tighten the nut located right above the white plastic float. Turn the float switch clockwise to increase thickness and counterclockwise to decrease.Aug 13, 2014
How Long Does It Take Ice O Matic to make ice?
In most modern ice makers, you can expect them perform quickly. They usually take about 90 minutes to produce around 10 cubes of ice. It will then cycle about 16 times per day or until the ice bin is full.Jan 18, 2020
Why isn't my Ice O Matic making ice?
A bad contactor or coil might need to replaced, or it could be a broken compressor or starter components. Have an authorized technician replace these parts or the entire compressor assembly. Water leaking – Look for leaking out of the purge drain or water trough. Both could will prevent the production of ice.
Is there a reset button on a Ice O Matic ice machine?
https://www.youtube.com/watch?v=M-7Dluasgtg
How do you adjust the ice thickness on Ice O Matic?
The ice thickness can be changed on the Float Housing by turning the adjustment clockwise to decrease the bridge thickness and counter-clockwise to increase the bridge thickness. You will hear a “click” with each adjustment. it is recommended adjustments be made one or two “clicks” at a time.Oct 5, 2017
What does harvest cycle mean on ice machine?
Harvest Cycle Now it's time to “harvest” the ice. Remaining excess water is purged down the drain as gas warms the evaporator. As the evaporator gets warmer, the sheet of ice cubes slides into the storage bin. Assuming the cubes clear the water curtain (or ice damper), the machine moves onto another freeze cycle.Mar 26, 2021
Why is my ice O Matic freezing up?
Water's temperature is too warm – Hot water flowing to your machine can throw off the ice machine. It takes the evaporator too long to cool down the water and freeze it into cubes, and this trips a sensor within the machine. ... Impure Water – The most common issue that ice machines come from the water they use.Dec 15, 2017