Either use a stud finder or tap gently on the wall with a hammer and listen for hollow vs more solid sounds. You will want to avoid the studs for the obvious reason and because there could be wires running along them. Drill a hole in one side of the wall, using the size of drill bit that the cable will fit through.23 abr 2017
How do you pass a cable through a wall?
https://www.youtube.com/watch?v=NwXAWsp9wps
How do you drill a cable in a house?
https://www.youtube.com/watch?v=fpFUxlcH2Lg
How do you get cables down a cavity wall?
Round off both square cut ends of the tongue with a file to form a blunt point. Drill a small hole (about 2/10 inch) in both ends of the tongue to enable a cable to be looped through. Push the tongue into the wall and feed it through until it appears at the other end.
How do you use a flexible bit?
https://www.youtube.com/watch?v=q-y0bmxWWRw
How do you fish a wire from the wall to the ceiling?
https://www.youtube.com/watch?v=eSMUnuoxdZQ
How does a bit in a drill should be attached?
Insert the drill bit into the drill chuck. Tighten the drill chuck only by hand until it clicks several times. Rotate the chuck back the opposite way, until you hear and feel one, single click. Once you hear and feel the last click, the drill bit is locked securely into place.8 jun 2017