Install cement board or an equivalent moisture-resistant backing material on walls behind tub and shower enclosures composed of tile or panel assemblies with caulked joints. Don't use paper-faced backer board, i.e., paper-faced drywall, behind seamed tub and shower enclosures.20 Dec 2017
How do you frame a shower tub?
https://www.youtube.com/watch?v=toYEniCpgYc
How do you prepare a shower wall for tile?
- Apply a layer of 1/2″ thick cement backer board to the wall studs.
- Tape any seams and corners with fiberglass tape.
- Apply thin-set adhesive over the fiberglass tape, and allow it to dry.
- Roll a waterproofing sealer over the walls, and allow the sealer to dry.
What goes behind a tile shower wall?
cement board
How high should tile border be in shower?
between 59 and 64 inches
What do you use behind a shower wall?
In showers, the standard substrate is tile backer, also called cement board or cement backer board.10 Sept 2021
Do you put drywall behind a shower?
The short answer to the question is, “It's not recommended.” However, this answer only really only suffices if you're converting a room that was never a bathroom into a wet space. Drywall on its own is not suitable for use in bathrooms because it is prone to absorbing moisture and thus losing structural integrity.
What type of drywall goes behind a shower?
Greenboard Drywall Definition Cement backer board such as Durock is best used for tile in highly wet applications such as shower stalls, with greenboard and other water-resistant drywall panels kept only to high-humidity areas.18 Jan 2021
Should you put plastic behind shower walls?
They are required beneath your shower pan and behind your shower walls. Moisture barriers can be made of polyethylene or a membrane that is rolled directly onto the drywall. No matter what they are made of, without them, your shower is subject to moisture damage.
How do you frame a wall with a niche?
- 1 Lay Out Niche. Determine that the wall you're cutting into is not a load-bearing or exterior wall.
- 2 Cut Deeply Into Wall Studs.
- 3 Finish Cut with a Reciprocating Saw.
- 4 Rip-Cut Frame Boards to Width.
- 5 Assemble Niche Box.
- 6 Trim Out Niche.
- 7 Fasten Niche Box.