- Dig Under the Concrete. Dig out the soil, gravel, or other material from under the concrete, using a shovel and a pickax or mattock. ...
- Strike the Concrete. Lightly sprinkle the concrete with water to minimize dust. ...
- Pry Off Stubborn Pieces. ...
- Move the Concrete Chunks With a Hand Truck.
What is the easiest way to remove concrete?
- Step 1: Create a Void Under the Concrete. The best way to speed up concrete removal is to create a void underneath the section of slab you're working on. ...
- Step 2: It's Hammer Time. ...
- Step 3: Pull Apart and Remove the Broken Concrete. ...
- Step 4: Repeat Steps Until Concrete Is Demolished.
How do you remove concrete footings?
Steps in Removing Concrete Deck Footings Using a spade shovel manually excavate around the footing at least 3/4 the way around and at least 2/3rds of the length of the footing. Dig until you see the footing wiggle a bit. The more you dig the easier the footing will come out.
How do you remove a concrete slab without a jackhammer?
https://www.youtube.com/watch?v=WoTZsQSMqes
What is used to break up concrete?
Start to break the concrete, starting six inches from the edge and working your way in. For slabs less than four inches thick, use a sledgehammer. For more than four inches thick, use a demolition hammer.
How do you crush concrete gravel at home?
Strike the slab with a sledge hammer about 12 inches from the point where the pickax touches the underside of the slab. Do this repeatedly, and after a short time the slab will break up into small pieces.
How do you break down an old concrete driveway?
Jackhammer to break up concrete that's thick. If you're trying to remove concrete 3 inches deep or more, a jackhammer is your go-to tool. Rentable electric units will likely knock out that run-down sidewalk at the end of the driveway or small patio.
How do you break concrete footings?
Break the concrete footing into two or more sections, using a cold chisel and steel mallet. Drive the tip of the chisel into the seam between the base of the post and top of the concrete until the concrete breaks. Repeat this on the opposite side of the post.
Can you overlay old concrete?
When it's time to upgrade, that makes it a natural question to ask. Fortunately, it is possible to place stamped concrete over existing concrete. Stamped concrete overlays are durable options for upgrading, repairing, and enhancing existing concrete.
Can you pour new concrete next to old concrete?
You can put new concrete over old concrete. However, unresolved issues with your old concrete, such as cracks or frost heaves, will carry over to your new concrete if not taken care of. In addition, you must pour it at least 2 inches thick.17 ago 2020