- Press and hold the PROGRAM button until both LED lights turn BLUE.
- Release button. ...
- Press and hold the PROGRAM button again then release. ...
- Enter your PIN number using the keys on the keypad.
- Press the UP/DOWN button. ...
- Press the UP/DOWN button again. ...
- Press any key to stop opener.
How do you reset the code on Overhead Door legacy?
https://www.youtube.com/watch?v=pLD83NbeYi4
How do I program my overhead door legacy garage door remote?
Press and hold the two outside buttons on the HomeLink® system until the LED starts to blink, release buttons. While the LED on the garage door opener is blinking, return to the vehicle and press the pre-programmed HomeLink® button 4 times. (Or until the garage door operates).
How do I program my outdoor garage door keypad?
https://www.youtube.com/watch?v=KVNP_c8GBRk
How do I reset my legacy garage door keypad?
- Open the keypad cover half way.
- Press and hold the number 8 and the PROG buttons while opening cover fully.
- The indicator light will blink once and go out.
- Close the cover. You are now ready to re-program your keypad.
Where is the Learn button on Overhead Door legacy?
The "Learn" button on your garage door opener is located above the antenna wire that hangs from the motorhead, it may also be under a light cover. The "Learn" button will be either green, red/orange, purple or yellow.