Check if the engine light is still on after the Mass Air Flow Sensor was replaced. The entire system can be reset by unhooking the battery and leaving it unhooked for 10 minutes. Keeping the battery unhooked for longer than 10 minutes won't hurt anything.
Can a dirty air filter cause P0102?
The primary reason for a P0102 code is restricted airflow. This situation is caused by a dirty or clogged air filter. Upon stepping on the gas, the engine needs to ingest a lot of air.
How do you fix a low voltage on a MAF sensor?
https://www.youtube.com/watch?v=njuKIQ8d83Y
What causes a mass air flow sensor code?
The mass air flow (MAF) sensor measures the amount of air entering the engine. Check engine light code P0101 is set when the measurement of air entering the engine by the mass air flow sensor is outside of the manufacturer's specified range.
What would cause a P0102 code?
A trouble code P0102 is triggered when there is low airflow registered by the Mass Air Flow, or MAF, sensor.
What does mass or volume air flow circuit low input mean?
Diagnostic trouble code (DTC) P0102 isn't in every vehicle's code library, but whenever it appears it means “Mass Air Flow (MAF) Circuit Low.” The code is set when the ECM/PCM perceives a problem with the mass airflow (MAF) sensor's performance. The MAF sensor is mounted between the air filter and the throttle body.
How do you clean a MAF sensor at home?
https://www.youtube.com/watch?v=gRfaPfTcfOM
Can I just clean my MAF sensor?
We recommend that you clean the MAF sensor every time you change your air filter. Carefully remove the sensor from the air duct and disconnect the electrical connector. Spray 10 to 15 spurts of the mass air flower cleaner onto the wire or plate. Don't scrub the parts; you may break the wire or damage the plate.
What are the symptoms of a dirty MAF sensor?
- Stalling, jerking, or hesitation during acceleration.
- air fuel ratio is too rich.
- air fuel ratio is too lean.
Is it better to clean or replace a mass air flow sensor?
MAF sensors can become damaged, but more often they just get too dirty to do their job well. In this case, they can be cleaned but if it is a mechanical or electrical failure, they must be replaced.
What voltage should a MAF sensor read?
Depending on your MAF sensor, your voltage reading should be between 0.60 to 0.80 volts at idle. If your reading indicates 12 volts or pretty close to it, you are probing the power wire, not the signal wire).