Do not thin if using a roller or brush; however, if using a sprayer and thinning is required, thin with water at a rate of no more than 1/2 pint per gallon.
Should you thin paint when using a sprayer?
Yes, the latex paint does need to be thinned. Even though latex paint is water-based, it is thicker than the oil-based paint varieties. The thick latex paint needs to be thinned to be able to spray a fine mist of paint. Before applying your paint, it is a good idea to test out the paint's viscosity.
What is the ratio of paint to thinner for spray gun?
Step 2: Use the Right Amount of Thinner Check paint container labels for the manufacturer's recommended paint to paint thinner ratio. For general purpose thinning, a 3:1 or 4:1 ratio of paint to thinner or similar ratio is appropriate. It is important to keep the amount of paint higher than the amount of paint thinner.
Can Behr marquee paint be sprayed?
Chris, Marquee can be sprayed. Depending on the sprayer being used, specific settings on that sprayer may be recommended. Refer to the back of the label for these specific recommendations. You will also be able to find these recommendations under the products section at behr.com.Jun 20, 2013
Can you use a paint sprayer for Behr deck over?
Can I use an airless sprayer to apply BEHR PREMIUM ADVANCED DECKOVER Coating? Airless spray is recommended for experienced applicators only. ... When spraying vertical surfaces, apply a very thin coat (one pass only per coat) and do not back brush/roll.
Should latex paint be thinned for spraying?
Is it necessary to Thin Latex Paint for Spraying? Yes, the latex paint does need to be thinned. Even though latex paint is water-based, it is thicker than the oil-based paint varieties. The thick latex paint needs to be thinned to be able to spray a fine mist of paint.
Can Behr cabinet paint be sprayed?
Spraying Behr PREMIUM® Cabinet Paint To Spray Behr PREMIUM® Cabinet Paint, an airless sprayer isideal. An airless sprayer will also provide a smoother finish than a roller or brush. To get the smoothest finish possible, a fine finish airless tip will be best. ... You can spray at around 1700- 2000 PSI.