Connect the cable going from the DEVICES connector to the first Device Station to be connected. Use the T-shape splitter and short RJ cable so that the first cable can continue on to be connected to the next T-shape splitter (Device Station) to be connected. Plug the Device Station to the wall outlet for power supply.
How do you calibrate a TrolMaster?
- On the HCS-1 go to System – Calibration. / ...
- Next select the item you want to calibrate.
- Using your observed reference temperature or humidity reading, change the calibration on the TrolMaster controller to read the same readings. ...
- The sensor is now calibrated to your new reference point.
Where does the TrolMaster sensor go?
https://www.youtube.com/watch?v=Bbs_OfyWm6o
How do you connect a TrolMaster to a dehumidifier?
Peel off the outer sheath of all signal cable of a dehumidifier to reveal the copper wire. Then, insert each bare wire into the corresponding terminals on the back panel while pressing the button of the terminal designation at the same time. Release the button to clamp the wire in each terminal.
How do you connect CO2 to TrolMaster?
Connect the CO2 sensor to the controller. Plug the Controller into a 120V NEMA 5-15 wall outlet. Program the desired settings before connecting to CO2 generator or regulator. Plug the CO2 device into the power outlet of the unit.
How does the TrolMaster work?
The system comes with a 3-in-1 sensor detecting temperature, humidity & light. A CO2 sensor is available for measuring CO2 level. When the measured value exceeds your custom setting range, a warning message will be sent to your smartphone.