For handling pallets, ideally your forks should be spaced equally apart center to the carriage/backrest, around 10 inches out from each side. But really there is no exact measurement; the best rule is to space them just a bit less from as wide as you can have them for the pallets/loads you will be handling.
What is the standard distance between the forks on a forklift?
Counterbalance forklifts, also known as a forkift trucks, fork trucks or forklifts, are the most common type of material handling equipment and are characterised by a lifting unit, which consists of a mast and, typically, a forklift fork with 1.2 metres distance between the forks.
What is the load Centre distance on a forklift?
Load Centre Distance: Is the distance from the vertical face of the fork arms to the centre of gravity of the load (see diagram below).
How far apart can forklift forks go?
RE: Forklift Feet Spacing Standards High capacity forklifts can have fork spacings as much as 9 or 10 feet. Generally, the forks can be adjusted from almost no clearance between them to the maximum spacing of the particular lift truck.Jan 4, 2011
What is the width of the forks on a forklift?
Fork Width – Fork width is commonly 4-inches for Class II, 5-inches for Class III, and 6-inches for Class IV. This keeps them within their capacity limits for their classes. Of course, some people will need narrower forks or wider forks depending on the application.
How long should forklift forks be?
ANSI (American National Standards Institute) states that the forks you are using go at least 2/3rds the length of the load. For instance, a 4 foot long fork can pick up loads up to 6 feet. When doing this the load needs to be evenly distributed on the pallet or the heavier end must be closest to the forklift.
How low should forks be driving forklift?
Keep the forks 6 to 10 inches above the ground to avoid potential hazards on the ground. Remember that forklifts are top-heavy. Carry the load low and tilted back. Use caution when carrying a load on an uneven surface; it creates a tip-over hazard.
How far should forks go under the pallet?
Slide the forks into the pallet until they are fully under the load. The forks should be at least two-thirds the length of the load. Be careful that the forks do not go through to the other side where pallets are closely stacked. Center the weight of the load between the forks.
When picking up a load the forks must be spaced?
Insert the fork all the way under the load (use forks that are at least two-thirds of the load length). Adjust the fork as wide as possible to fit the load and to provide a more even distribution of weight. Space the fork evenly from the centre stringer of the pallet to balance the load.
What is the most common load Centre distance on a forklift?
24-inches
How high should forks be when driving forklift OSHA?