How long does a CO2 laser tube last?
Do you use a CO2 laser engraving machine?Do you know how to use a Co2 laser?MORN shows you how to use a CO2 laser tube correctly and prolong the lifetime of your machine.
In order to extend the service life of a CO2 laser engraving machine, you should pay special attention to the 8 points in this post.It will help you understand the maintenance of the laser tool.
Keep the temperature of the cooling water in the range of 12 to 30 degrees by connecting the water chiller or pump to the laser tube.
The water in the pump should be connected to the laser tube so that the water can flow smoothly.The power should be turned on when the outlet pipe is adjusted to make sure the cooling water is not a bubble tube.The water temperature should be controlled in the range of 12 to 30 degrees and the cooling water should use soft water.If the water temperature is too high, please replace the cooling water in time or it will break down the laser tube.The cooling water can't be frozen in the winter because of the laser tube not being able to retain it.The use of alternating current users must be stopped.
If the flow of cooling water at 2L-4L / min is not ensured, the working accuracy will be worse and the power will go down.If the cooling water outlet mouth is not covered by water, a laser tube will be unfilled and easy to damage.
If you don't protect the laser output mouth, power will decline, and the available cotton wool or silk output dipped gently wipe the outer.
The best output effect can be achieved by adjusting the laser tube anchor or rotating the tube orientation.
To keep high-pressure metal away from the end and prevent the high voltage discharge, make sure there is no dust in the vicinity of the electrode.
The cooling effect of variation can be avoided by forming a cooling pipe scale during use.The scale can be removed if the available 20% of hydrochloric acid is found.
The best output power is under eighty percent.