Cars & Other Vehicles

How To Build a Talk Box

A guitar effect that uses the power of your mouth is called a talk box.

Step 1: You should get a computer speaker.

Step 2: The speaker needs to be removed.

Step 3: Attach the wire to the light.

Step 4: The container should be flipped upside down.

The lid should be on the ground.

Step 5: The speaker should be put in the Tupperware container.

Only the wires and the speaker go inside the container if the circuit board is outside.

Step 6: The bottom of the Tupperware container should be facing the speaker cone.

Step 7: Attach the speaker to the duct tape.

Don't use Duct Tape on the speaker cone.

Step 8: Take out a drill with a large bit and a little bit smaller than the width of the tubing.

Step 9: There is a hole in the Tupperware.

It's important to avoid cutting into the speaker cone.

Step 10: Attach your tubing to the hole.

The speaker cone should be at least 1/2 away from the tubing.The speaker cone must not be touched by the tube.

Step 11: The tube was closed by duct tape.

You might want to use hot glue as well.

Step 12: When the container is full, put cotton balls behind the speaker.

The cotton balls should not touch the speaker cone.

Step 13: The Tupperware lid needs to be closed.

Step 14: The lid needs to be Glued down.

Step 15: Attach the Tupperware to the box.

Put the socks and T-shirt in the Tupperware.

Step 16: The box needs to be closed.

Step 17: If you want the tubing to go through, you have to drill a hole in the box.

Step 18: If you want the cable to go through, you have to drill another hole in the box.

Step 19: Plug the cable into the speaker jack.

Step 20: The volume should be turned up to 3 o clock.

No sound will come out of your amplifier.

Step 21: The gain should be turned to 3 o clock.

Step 22: To check for sound, put the tube next to your ear.

Step 23: You should put the tube in your mouth.

Lip movements, but no sound.Pretend you are lip-syncing.You have the right to say what you want.