How to Fix a Large Dent in a Car Door is a video.
Your personality and lifestyle are reflected in the appearance of your vehicle.You don't have to break your bank just to do this.Minor dents and dings can be repaired on your own.There are many ways to fix these problems with ease.You don't need to be a mechanic to use the solution successfully.
We are going to teach you how to fix a large dent on a car door.The thin sheets of metal stretched over the frames are prone to dents.They are not as strong.You don't have to take your vehicle to a professional body repair shop to fix them.
The area around the dent should be wet with dish soap and water.Put a plunger in the center of the dent.Press it against the door panel.
Pull the plunger back gently to pop the dent out.Pull harder if the first pull doesn't work.You need to pull harder to get the dent out of the panel.If the dent is still there, you can release the suction by sliding the plunger down.The soap needs to be washed off the door panel.
You need a small container to hold all the screws you need to remove from the interior door panel.You can find them if you put the door panel back in place.
The door should be open as wide as possible.Remove all the screws from the door panel with a Phillip screwdriver.There are screws below and above the door panels.The screws should be removed from the inside pockets.Pop open the small circle or square covers with a flat screwdriver.
You need to remove the internal panel from the door.You can pull it away from the edges.The door wiring needs to be disconnected from the back side of the interior panel.Behind the panel is where the wiring should be located.Lift the panel up and pull it off the door after you disconnected it.
The metal door frame keeps the plastic sheet stuck on it.You have to peel it off.It's a good idea to lay it flat on a clean area.You can reuse the plastic sheet in this way.