How to fix the E6 error code on the Gree Air Conditioners.
Check if the jumper contacts correctly.If the old PCB is to be replaced, please take it off.
There is a malfunction of the indoor ambient temperature sensor.
If the evaporator temperature is connected properly, there is a malfunction of the temperature sensor.
If the indoor motor's terminal is connected correctly, the fan block will work.If the fan motor is disabled, replace it.
As the unit reaches the temperature point, it will stop operating.During cooling and drying operation, compressor stops and indoor fan operates.
A/C status includes indoor fan, outdoor fan and compressor.The horizontal louver stops at the current position.
There is no jumper cap on the controller.The jumper cap is not tight.There is a damaged jumper cap.The controller is damaged.
During cooling and drying operation, compressor and outdoor fan stop.
All loads stop operating during cooling and drying operations.The complete unit stops during heating.
During cooling and drying operation, compressor and outdoor fan stop.All loads stop during heating.
During cooling and drying operation, compressor and outdoor fan stop.All loads stop during heating.
The compressor stops while the indoor fan motor is running.The complete unit stops during heating.
The compressor will stop while the indoor fan is running.The complete unit stops during heating.
During cooling and drying operation, the compressor stops while the indoor fan is running.
It is possible that the outdoor temperature sensor is damaged.Referred to as the resistance table for temperature sensor, please check it.
During cooling and drying operation, the compressor will stop operating after 3 minutes, while the indoor fan will start operating.
During cooling and drying operation, the compressor will stop while the indoor fan is running.
During cooling and drying operation, the compressor will stop, while the indoor fan will operate.
There is a possibility that the outdoor unit's control panel AP1 needs to be replaced.
During cooling and drying operation, the compressor will stop while the indoor fan is running.
Refer to the malfunction analysis for possible causes.
Defrosting will occur in heating mode.The indoor fan will stop operating.
During cooling and drying operation, the compressor will stop while the indoor fan is running.
During cooling and drying operation, the compressor will stop while the indoor fan is running.
During cooling and drying operation, the compressor will stop while the indoor fan is running.
Refer to the malfunction analysis for possible causes.
During cooling and drying operation, the compressor will stop while the indoor fan is running.
During cooling and drying operation, the compressor will stop while the indoor fan is running.
Refer to the malfunction analysis for possible causes.
During cooling and drying operation, the compressor will stop while the indoor fan is running.
During cooling and drying operation, the compressor will stop while the indoor fan is running.
During cooling and drying operation, the compressor will stop while the indoor fan is running.
During cooling and drying operation, the compressor will stop while the indoor fan is running.
During cooling and drying operation, the compressor will stop while the indoor fan is running.
The complete unit will stop during cooling and heating operations.
If the thermal grease on the IPM Module of the outdoor control panel AP1 is not enough, the unit may be unsafe.Control panel AP1 should be replaced if it is no use.
During cooling and drying operation, the compressor will stop while the indoor fan is running.
During cooling and drying operation, the compressor will stop while the indoor fan is running.
If the thermal grease on the IPM Module of the outdoor control panel AP1 is not sufficient, then the complete unit may be discharging.Control panel AP1 should be replaced if it is no use.
The complete unit will stop operating if this malfunction occurs.
During cooling operation, compressor will stop while indoor fan will operate; during heating, complete unit will not operate.
If the power goes off, contact the service center.Don't repair the air conditioner yourself.Incorrect repairs can cause fire.You can contact the service center.Children shouldn't use the appliance without supervision.
The green unit lights up when the indoor unit fails.The fault code can be deduced from the number of green flashes.There is a pause between one flash cycle and the next.
The models are: GWH09KF-A3DNB1A/GWH12K-D3B1C.
Some problems can be solved without the help of the Customer Service department by checking the following.
Contact the Customer Service department if the problem persists after you check the following.
It is normal for the system to generate condensate water in cooling mode, but it is designed to drain this water via a condensate drain system.
When cooling warm humid air for a long period of time, it is normal for the system to develop condensation on the discharge air louvers.
As the system cools and dehumidifies the room space, the condensation will disappear.
There is a built-in three-minute delay to prevent short and/or rapid cycling of the compressor.
Typically unpleasant odors are the result of mold or mildew forming on the coil surfaces or the air filter.
The solution is to wash the indoor air filter in warm water.A qualified service professional can clean the coil surfaces if odors persist.
It is normal for the system to makegurgling sounds when the compressor starts.
The system should equalize after two or three minutes.
It is normal for the system to emit a mist when the air is very warm.
It is normal for the system to generate condensate water in cooling mode, but it is designed to drain this water via a condensate drain system.
When I start a split after 3 minutes, the compressor suddenly power on and off, and only the fan in the indoor works, I have a problem.
I discovered E 7 problems.What does it mean?There is no solusion in the maual of use.Please help me.
The air conditioner GREE KFR-35GW has an error code.I don't know what to do for this error.Can anyone help me with this?
What does this mean?Sometimes, I get it, but then ac works fine after some restarts.
I have an ac gree that splits after 30 minutes, please anybody help me?
I have a gree DC unit that was put on the roof after a storm, but it stopped working when I replaced it, so I don't know what to do.Thank you.
A few minutes after turning on my gree ac, it displays an error.What should I do?
I have a mini split of 1200 square feet with a code on it.How do I fix this?
There is a Cassette Ac O.The General 2ton indoor unit has a green light.When it was on for the same time, it started blinking.
There is a code on the indoor display.After shutting the unit down, it will work later.I don't see the code in the manual.What is it?Thanks.
I have a split unit that runs on heat mode, but when it's time to start again, it goes into cold air.
After h1 I loose the hot air, what's the problem?
During cooling and drying operation, the compressor will stop while the indoor fan is running.
Refer to the malfunction analysis for possible causes.
Comment: "id", "a3d0e0f31739e5985af849c9d50aab14"
Related Posts:
- Carrier AC Error Codes, Carrier Dc Inverter Air Conditioner EC Error Code, and Carrier Jasa service ac error codes are listed.
- There are preventative causes of AC Compressor Failure, so you were told you have a bad compressor.
- How does an automatic expansion valve work? PDF Thermostatic and Automatic Expansion Valves For Refrigerators
- Why does my air conditioning compressor turn on and off?