How To Subnet a Class C Network

If you have a large network, you might want to create smaller networks.You can easily manage them.Smaller networks are less likely to cause crashes.It can be hard to set up a Class C network.It is a crucial skill to know.The following steps are needed to subnet a Class C network.

Step 1: The host's subnet mask should be checked.

The location of the host's subnet is information you can get when you check these.The address for the broadcast.The valid host's range is used to set up hosts.

Step 2: Find out the address of the broadcast.

The broadcast address is not a valid host address.You cannot assign it to a host configuration.It will be easier to find the host address when you know what the broadcast addresses are.The real host range consists of numbers between the broadcast address and the subnet address.

Step 3: The quantity of subnets should be obtained.

The number of subnets can be found using the formula: 2n.The number of bits in the mask is the n component.The smallest part of a computer's data is called a bit.The value is either 0 or 1.0 means off and 1 means on in computer terminology.The bit is 1, which means it's on.

Step 4: Get the number of hosts.

The formula for finding the amount of hosts is 2n - 2.The number of host bits in the mask is called the n component.The bit is off for host.

Step 5: You will need a mask for the network.

You have to find the number of sub-networks as well as the hosts for each network.You will need to use the same formula after you get this information.

Step 6: Refer to the Class C mask.

The best way to memorize Class C masks is to create sub-networks.There is a default subnet mask.You can find these masks in computer networking books.

Step 7: Decide which Class C mask to use.

After determining your networks and hosts, perform this step.If you want to make eight sub-networks.Each of them requires at least ten hosts.You would use a Class C mask.This is the reason for it.The host bit is not the same as the subnet bit.There are four bits for the host in the same year.The formula 2n - 2 will give you 14 subnets and 14 hosts.

Related Posts:

  1. What is overlapping address?
  2. What does overlapping IP addresses mean?
  3. Sub-Zero's real name is not known, but what is it?
  4. The truth about 4K TV refresh rates is explained by Vizio.