How To There are Tie Rod Holes in a Poured Concrete Basement Wall.
The use of compressed swell plugs is the most advanced method for stopping water.Water-activated materials are more effective than conventional bonding materials in wet environments.Over a three week period, exposure to moist air will cause the polyurethane body to expand and cause additional seal pressure beyond the initial compressed seal.
Step 1: You can see the wall from a distance of five feet away after the first tie rod hole leak.
The others may appear to be irregular in the surface of the concrete if you look at the wall in this method.Every eighteen inches across the wall, most homes have tie rod reinforcement holes.The upper row of the eight-foot high walls is five feet from the floor.Ten-foot (3.05 meters) high walls will have three rows with the first row approximately three feet high from the floor and the remaining two rows higher.The upper and lower rows are usually aligned.
Step 2: When the 8 inch hole is fully exposed and the edges of the hole are hammered away, use a standard hammer.
The front of the tie rod hole is usually a 14 inch to 1/2” inch.
Step 3: The existing tie rod hole should be exposed to a depth of three inches.
The hole should be exposed to a 3 inch depth by using a standard screwdriver, tie rod bar, or dowel rod.The area may need to be drilled out using a masonry bit.It will be necessary to drill the hole out using a masonry bit if the tie rod hole has been repaired before.
Step 4: To remove debris from the tie rod hole, flush it out with clean water or vacuum it up.
Step 5: The exposed tie rod hole will be filled with a water activated compressed swell plug.
Step 6: Turn the end of the coupler.
Step 7: Once snug, lightly tap the end of the coupler with a hammer.
To tighten to a snug fit, use a 3/8 inch (9.53 millimeter) nut driver.It may cause the plug to spin or fail if you over tighten it.
Step 8: It is possible to find a suitable masonry product at home improvement stores.