How to turn on a sprinkler system like a pro. How do I manually start my system?

Many homeowners think it's difficult to turn on a sprinkler system in the spring.Depending on the size and complexity of the irrigation system, it can take as little as 30 minutes to turn it on.Depending on the size of the sprinkler system, the average professional service call could be as low as $75, or as high as $1,000.The spring turn on gives a good opportunity to look at all the components and see what is working and what isn't.It's time to call in a professional if the sprinkler system has broken components.

Depending on the area's last frost date and projected spring and summer weather, sprinkler systems are turned on at different times of the spring.It is normal to wait until a few weeks after the last frost date when pipes are not at risk of freezing.It will be later in the spring for the northern states.

The water must be turned on slowly so that the pipes are not damaged by the water hammer.

It is easy to start an irrigation system in the spring.The water must be turned on slowly so that the pipes are not damaged by the water hammer.The water can cause problems if it is turned on too fast.If you are turning on a valve, make sure to open it slowly and give it time to pressurize before opening it all the way.This guide will show you how to start a sprinkler system.

Depending on the area, the number of sprinkler heads and the status of the system, opening up your sprinkler may take a couple of hours.Shutting down the system for winter and reestablishing it in the spring are both difficult tasks.The only thing to worry about is avoiding the sprinkler heads with the lawn mower.

To make sure the lawn agrees that winter is over, it is necessary to use a shovel to dig at least one foot into the soil in a remote part of the yard.You should wait a few more weeks before trying another dig test if the ground is still frozen.

The sprinkler system can be damaged when the ground is still frozen.It might be necessary to hook up the hose and perform the old-fashioned method while the soil thaws if watering can no longer wait.

Most of the valves turn 90 degrees in a clockwise direction.When this valve is turned on, it will sometimes leak a little, but only for a short time.Make sure the valve is not continuously running.

There are two ball valves on each side of the vacuum breaker valve.If the ball valve is in a parallel position, the valve will be turned off.A quarter turn is all it takes to turn on a ball valve.Make sure to turn on the valve slowly.It's a good time to check the individual sprinkler valves.

Take some time to check the sprinkler heads.It may take a while to find a broken or damaged line.Fix any leaks and replace broken sprinkler heads.Make any necessary modifications and adjustments to the spray pattern of the sprinkler heads and let it run for some time and check the coverage.The spray heads might need to be cleaned or adjusted before they work again.

If the sprinkler system is ready for its initial watering of spring, you won't need to make any changes to your nozzles.It is beneficial to test the irrigation of each zone at a time.Make sure your spray patterns are getting water where you need it.

Keep an eye on your sprinklers while you use the control panel to start the irrigation program.If you have broken sprinkler heads, this is when you will most likely notice them.If your sprinklers have low pressure, that is a sign of a water line break.You should turn off the sprinkler system until you can fix the break and watch for soaked areas to develop in your soil.

You should be familiar with the basics of your timer.If you need an instruction manual, it can be found online and printed.To begin with, programming the sprinkler system timer and setting up various programs for different zones, and always make sure the controller is set up properly.Ensuring that the current day and time are correct is the most important part of doing that.