How wide of a board can a sliding miter saw cut?How wide can it be if it is a 12 inch board?
The 12-inch version has a maximum cut of about 7 1/2 inches, wide enough for two-by-eights.The saw can cut through four-by-fours with a maximum thickness of 3 1/2 inches.
How big of a board can a 10 inch sliding miter saw cut?You can use a sliding saw to cut 24's at a 45 degree angle.With the same 10 inch blade, you can cut into wood or plywood up to 2 inches, as opposed to just 1.25 inches with a non-sliding miter saw.
More than twice the width of a non-slider, the sliding saw can extend its reach to 12 or even 16 inches.Every day you will thank yourself for buying the sliding miter saw if you work with boards this wide.All your cuts will be more precise since you only cut once.
A 12-inch saw blade is larger than the 10-inch blade and can cut larger pieces of wood.It will be easy to take care of the 44 with an appropriate saw.
A 10 inch blade on a miter saw can cut through a 44 in one or two steps, but this may not be enough from a practical standpoint.If you want to get the job done quicker and easier, you should consider either a 12 inch or 10 inch sliding miter saw.
The teeth on the saw are used to cut angles.The 90-degree cut can be done as a chop saw, but it can also do angles, bevels, and compound cuts.If you're making picture frames, trimming out doors and windows, or putting in moldings, a miter saw is a lifesaver.
The main difference between a chop saw and a miter saw is the rotation of the saw.Chop saws have 90-degree angles.Chop saws are hardy machines that will cut through anything.
Should you buy a table saw or a miter saw?A table saw can make longer cuts than a miter saw.If you have a jig, a table saw can make the same cuts.
You have plenty of wiggle room with a 10-inch saw because the trim is usually less than 4 inches.Smooth cuts can be made with a 10-inch blade instead of a 12-inch one.The 10-inch blade will have a higher RPM rate if the two blades are powered by the same motor.
It would take a jig or straight edge to cut angles with a circular saw.You can change the angles with a saw.The saws have a kickback when they fire up.
Simply divide the angle reading by 2 to calculate the proper angle for trim-work.The inside corner is nearly square.The angle of your moldings should be 45.25 degrees.
Unless you are cutting large baseboards, I would recommend using a 10 or 12-inch saw.A 10-inch saw can cut 6-inch baseboards.If you already have a 12-inch saw, it's fine to cut baseboards.
If you know you're going to use it, but don't know what kind of work you will be doing, a sliding miter saw might not be necessary.They need a lot more space than a compound miter saw.
The formula uses the number of sides to calculate the corner angle.Divide it by two to get the angle.If you're making a five-sided project with all sides equal, you divide by five to get 72 degrees.Each corner has a 72 degree angle.
When you have a lot of work to do, the dual-Bev saws are the best choice.When making repetitive cuts, they are the best saws.There is no need to change the material.
The blade diameter of the saws varies from 10 inches to 12 inches.The bigger the blade, the deeper it is.A 10-inch saw will cut a 2 x 6 at 90 degrees and a two x 4 at 45 degrees, while a 12-inch will do the same.