I cannot open the drawers on my craftsman tool chest.
After using it for a long time, your storage cabinet's drawer unit may be stuck or jammed.Some people have trouble opening the drawers with the lock mechanism.
The quality and utility of Craftsman metal storage's are well-known.Professionals use these models to store their equipment.Sometimes a tool or something stuck behind the drawers can stop a drawer from coming.
Dirt and grease close the drawers slide.The drawer glide can cause a tool to be stuck between it and the slide.You need to open or remove the drawers to clean them.
There are three types of Craftsman chest drawers.I will show you how to open or remove your craftsman tool chest drawers.
Pull out the drawer at its end and lift it up.It will be easy to remove from the chest.You should enter the drawer from a downward position if you want to install it again.The process can be seen on the other two types of the drawer.
Take out the drawer content that you want to open.You can't open the drawer with tools because they are heavy.
There is a small lock at the two ends of the drawer.The locks prevent the drawer from being emptied.There is a strap between the slide and glide.Make sure you keep your strap on the lock.
Pull the side of the lock and it will come off.Do the same thing on the other side of the drawer.
There is a lever or tab in the outer rails.Lift the levers in the opposite direction of the current spot.The drawer will open easily.
The slide lock bar will release the drawer if there are drawer tabs or clips.
The tool chest locks are used for internal security.That's why the chest is locked.All the drawers will be locked once you lock the point.
Take a screwdriver.Take a thin metal strap and bend it at the top.The lock has a rectangular hole.
To get to the lock, you need the strap and screwdriver.The screwdriver should be pressed tightly.You feel safe.The strap should be similar to a key when the lock is replaced.You can open the drawers when the lock opens.
The chest lock needs to be unlocked.The tool chest has a top lid.Go to the connection side of the drawers.The lock stick has two to three latches on it.The entire system is locked when you lock the key.
A small screwdriver, a hammer and a thin metal stick are needed.Push the stick into the pin.The lock stick will release when the pin comes off.Do the same thing with other pins.
You can open your drawer without using the key if the lock action is no longer active.The pins can be set into the latch again if you fix the whole lock system.
You can remove the lock if you don't need it.You can open the drawer without a key.The lock has a key.Don't move the key.The key must be kept still.
Press and rotate the key clockwise after rotating the outer rail of the lock.The lock can be removed from the chest.You can do these steps in reverse if you reset the lock again.
I own a six drawer ball bearing chest and its drawers often stop during the opening.How can I fix the drawers on my chest?
There may be dirt between your drawers, glide, and slide.Something gets stuck there.Remove the drawer from the chest.
The key is rotating and the Craftsman chest lock seems ok.The chest is locked.I used the right key many times to pull and push the drawer.Nothing happens.
I think you have a jammed chest lock.To jerk the box, shake it.Wait a day and put some lubricant in the lock.It will evaporate if it is jammed for dirt.
The drawers or tray do not come out even with heavy pressure.You know how to open craftsman tool chest drawers in case of an issue.
I work at the chop shop in North Carolina.I've been a maker for the last 15 years specializing in cabinet building and custom retail fixture design and displays and my work has been featured at our family business as a wine shop.
Hello!This is my first visit to your website.A group of volunteers are starting a new project in the same community.The information you gave us was beneficial.You have done a great job.