Fasteners must be corrosion resistant, galvanized, or stainless steel. Electro-galvanized are acceptable but may exhibit premature corrosion. James Hardie recommends the use of quality, hot-dipped galvanized nails.
Can I use screws on Hardie board?
HardiePlank® lap siding may be used with fasteners approved by ICC-ES ESR-2290 spaced in accordance with the Wind Load Tables. Fasteners must be corrosion resistant, galvanized or stainless steel. ... Fasteners shall be installed between 1 in. and 3/4 in.
Is it OK to nail into Hardie board?
James Hardie recommends that nails be hot dip galvanized (at a minimum) or stainless steel (as a best practice). Anything less and the nails may start to rust, leading to stains on your beautiful siding.Feb 20, 2018
What kind of nails do you use to put up Hardie board?
NAIL TYPE: Fasteners must be corrosion resistant, galvanized or stainless steel. Electro-galvanized nails are acceptable for use with James Hardie Siding Products, but may exhibit premature corrosion. James Hardie recommends the use of quality, hot-dipped galvanized nails.
Can you put screws in Hardie plank?
James Hardie Building Products recommends keeping nails or screws at least 3/8 inch from the end of a plank. ... Drill pilot holes, at each mark, one-quarter to one-half inch deep, to make it easier to insert screws and prevent cracking the siding. Align the bracket holes with the pilot holes in the siding.
What is the best way to nail Hardie board?
Fiber cement siding can be nailed by hand or with a pneumatic nailer. It can also be attached using corrosion resistant screws. Use hot-dipped galvanized or stainless steel nails. Nails should penetrate through the sheathing and at least 1” into studs.
Can you use screws for Hardie board?
What is the correct fastener pattern for installing HardieBacker® cement board? Fasten HardieBacker sheets with proper nails or screws (as listed in ''Materials Required'' in the backer installation instructions) every 8'' around the perimeter and all supporting studs.
Can you put nails on Hardie board?
Hardie board comes with a 30-year manufacturer's warranty, but that means you need the nails to last at least that long too. James Hardie recommends that nails be hot dip galvanized (at a minimum) or stainless steel (as a best practice).Feb 20, 2018