To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.
How do I reset my GE washer?
Unplug the washer for one minute, then plug the washer back into the electrical outlet and lift and lower the lid six times within 12 seconds. This will reset the motor and you should be able to start the cycle.
How do you put a GE Deep Fill washer in diagnostic mode?
https://www.youtube.com/watch?v=46OamWEo9q4&vl=en
Why is my GE washer not starting?
Causes. When a GE washer stops working, it could be because of a broken spin belt, a blown fuse, a melted wire, a backed-up water pipe, or a burnt-out power outlet. The most straightforward reason your GE washer isn't working anymore is that it's not plugged into a reliable power source.
How do I reset my GE washing machine?
Unplug the washer for one minute, then plug the washer back into the electrical outlet and lift and lower the lid six times within 12 seconds. This will reset the motor and you should be able to start the cycle.
Why won my GE Deep Fill washer won't drain?
A kink or clog in your washing machine's drain hose could be interfering with water flow and preventing your machine from draining properly. To inspect the drain hose, turn off the power to the washer, disconnect the hose (have a bucket ready to catch any water), and check the hose for damage or obstructions.
Why won't my GE Deep Fill washer spin?
If your washer won't enter the spin cycle, check that the load is properly balanced. ... Clean the filter of any debris and then replace it, reassembling the washer. A clogged household drain can also cause water to stand in the washer and prevent the spin cycle from starting.
How do I put my GE washer in diagnostic mode?
https://www.youtube.com/watch?v=46OamWEo9q4&vl=en
Is there a way to reset a GE washer?
Unplug the washer for one minute, then plug the washer back into the electrical outlet and lift and lower the lid six times within 12 seconds. This will reset the motor and you should be able to start the cycle.
Can you hard reset a washing machine?
To reset your washing machine, unplug it from the power outlet. Then, plug the washer cord back into the wall. Finally, open and close the washing machine door six times to send the reset signal to the system components.
Why did my GE washer stop working?
Causes. When a GE washer stops working, it could be because of a broken spin belt, a blown fuse, a melted wire, a backed-up water pipe, or a burnt-out power outlet. The most straightforward reason your GE washer isn't working anymore is that it's not plugged into a reliable power source.
Is there a reset button on a GE washer?
To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.