Stacking using a couple of Catalyst 3650 and 3850 switches is done by the community.
I'm going to install 2 new switches.I used a stack cable to connect the switch and I can see that both the switches are in tack.
The local Mac address of the switch#sh switch is : 005d.73d7.3700.
I want to change one switch from master to priority.I thought to use'switch stack-member-number priority new-priority- number' but it wasn't accepted.There is no priority option after'switch stack-member-number'.The output is below.The priority should be changed.
I want to add a rack switch to my master switch and connect the stack ports to other switches which are already in the rack.The master switches will down load the config and I will keep them.
The command: show switch can be used to identify the rear of the switch's MAC address.