The best Chevy Cruze battery terminal is from $4.99.
Try to use another vehicle and jumper cables to start your vehicle if the battery has run down.The following steps need to be used safely.There is a warning that batteries can hurt you.They have acid that can burn you.They have gas that can explode.They have enough electricity to burn you.Some or all of these things can hurt you if you don't follow these steps.Ignoring these steps could result in costly damage to the vehicle that wouldn't be covered by the warranty.If you try to start the vehicle by pushing or pulling it will not work.1.There is a battery negative grounding point.The battery positive terminal 3 was discharged.There is a good battery negative terminal.The discharge battery's jump start negative grounding point is the engine block or an engine mounting bolt.You can connect to a spot as far away from the discharged battery as possible.There is a jump start positive terminal in the engine compartment of the vehicle.The jump start positive terminal and negative terminal are on the battery of the vehicle.The discharged battery has a positive jump start connection.To expose the terminal, open the cover.1.Take a look at the other vehicle.It needs a 12-volt battery with a negative ground system.Only a vehicle with a negative ground for jump starting can be used.Both vehicles can be damaged if the other vehicle does not have a 12-volt system.2.The two vehicles should be positioned so that they are not touching each other.3.Put the shift lever in P (Park) with an automatic transmission if you want to.If accessories are plugged in during the jump starting procedure, they could be damaged.The repairs wouldn't be covered by the vehicle warranty.When jumping starting a vehicle, always turn off the accessories on either vehicle.4.The ignition needs to be locked/off.If the hazard warning flashers are needed, turn off all lights and accessories.An electric fan can start up even if the engine is not running.Keep hands, clothing and tools away from an electric fan.A match near a battery can cause a blast.Some people have been hurt doing this.If you need more light, use a flashlight.The battery should have enough water.You don't need to add water to the battery.Make sure the right amount of fluid is in the battery.Add water to take care of it if it is low.If you don't, the gas could be present.Acid can burn you.Don't get it on you.If you accidentally get it in your eyes or skin, flush the place with water and get medical help right away.Fans and other moving engine parts can hurt you.When the engine is running, keep your hands away from moving parts.5.Attach the red positive cable to the positive terminal of the discharged battery.6.The positive terminal of the good battery is connected to the red positive cable.7.Attach the black negative cable to the negative terminal of the good battery.There are 8.The black negative cable needs to be connected to the negative ground point for the discharged battery.There are 9.Start the engine in the car with a good battery and run it for at least four minutes.10.The vehicle had a dead battery.It probably needs service if it doesn't start after a few tries.If jumper cables are connected or removed in the wrong order, electrical shorting may occur and damage the vehicle.The repairs wouldn't be covered by the vehicle warranty.Make sure the jumper cables don't touch each other or metal by connecting and removing them in the correct order.The reverse sequence is used to remove jumper cables.
Try to use another vehicle and jumper cables to start your vehicle if the battery has run down.
Ignoring these steps could result in costly damage to the vehicle that wouldn't be covered by the warranty.
If you try to start the vehicle by pushing or pulling it will not work.
The discharge battery's jump start negative grounding point is the engine block or an engine mounting bolt.You can connect to a spot as far away from the discharged battery as possible.
There is a jump start positive terminal in the engine compartment of the vehicle.
The jump start positive terminal and negative terminal are on the battery of the vehicle.
The discharged battery has a positive jump start connection.To expose the terminal, open the cover.
Only a vehicle with a negative ground for jump starting can be used.Both vehicles can be damaged if the other vehicle does not have a 12-volt system.
3.Put the shift lever in P (Park) with an automatic transmission if you want to.
If accessories are plugged in during the jump starting procedure, they could be damaged.The repairs wouldn't be covered by the vehicle warranty.When jumping starting a vehicle, always turn off the accessories on either vehicle.
An electric fan can start up even if the engine is not running.Keep hands, clothing and tools away from an electric fan.
The battery should have enough water.You don't need to add water to the battery.Make sure the right amount of fluid is in the battery.Add water to take care of it if it is low.If you don't, the gas could be present.
Acid can burn you.Don't get it on you.If you accidentally get it in your eyes or skin, flush the place with water and get medical help right away.
Fans and other moving engine parts can hurt you.When the engine is running, keep your hands away from moving parts.
5.Attach the red positive cable to the positive terminal of the discharged battery.
6.The positive terminal of the good battery is connected to the red positive cable.
There are 8.The black negative cable needs to be connected to the negative ground point for the discharged battery.
There are 9.Start the engine in the car with a good battery and run it for at least four minutes.
10.The vehicle had a dead battery.It probably needs service if it doesn't start after a few tries.
If jumper cables are connected or removed in the wrong order, electrical shorting may occur and damage the vehicle.The repairs wouldn't be covered by the vehicle warranty.
Make sure the jumper cables don't touch each other or metal by connecting and removing them in the correct order.