It's thought that you can only remove locks by cutting or shaving them off, but you're still able to open them.The process takes a long time and can be painful.
Step 1: Set a lot of time aside.
The process of getting your dreadlocks unlocked will take a long time.It can take four to eight hours for short locks to be undone.It can take 15 to 48 hours to change your locks.
Step 2: If there are large problems, address them.
If you want to remove individual locks and small knots, look for locks that have joined together and matted sections at the root.Use your hands to pull the areas apart.While doing this, be as close to the scalp as possible.If you can't remove these tangles without breaking your hair, it's best to work on the smaller locks first.
Step 3: You should wash your locks for 10 minutes.
To submerge your locks, fill a sink or basin with warm water and lean back.Allow your locks to soak for 10 minutes.
Step 4: The locks should be washed with a cleanser.
Work a small amount of detangling or degreasing on each lock.The lock should be washed with hot water.The water should be very hot.Any wax and grease that has built up should be melted with the hot water and shampoo.Thoroughly wash your hair.
Step 5: Put conditioner in each lock.
The conditioner should be applied to each section of the lock.Rub the conditioner into the locks.Don't rinse the conditioner out of your hair.If you have to, you can keep your hair out of your face by wrapping it in a towel.
Step 6: Pick the lock from the bottom.
To pierce the bottom of the lock, use a metal comb.Work your way up the lock in the same way.A tail comb is easy to use.The tip of the tail can be used to pierce the lock.You will need to work the teeth of the comb into the lock to use a regular comb.Pull the comb apart with your fingers after you insert it into the lock.Don't be afraid to apply a lot of pressure.If the locks are too difficult to untangle, use more conditioner and warm water into the hair.
Step 7: It's a good idea to remove the loosened portion periodically.
comb through the top of the loosened section down to the very bottom after pulling apart 1 inch.Every 1 inch is 2.5 cm.The unraveling process will lead to fewer problems if tangles and hair are removed.
Step 8: The locks should be repeated with the remaining ones.
You should repeat the process with the remaining locks after unraveling one.All of the locks need to be worked on one by one.It is possible to work the locks apart with a metal knitting needle or long sewing needle.When using a needle, slip the point into a loop near the edge of the dread and pull the loop out.Along the length of the lock, repeat as needed.
Step 9: Take care of your hair.
After you have unlocked it all, apply more conditioner to your hair.Allow the conditioner to sit on your hair for five minutes.Some of the damage caused by the picking process should be repaired by this round of conditioner.
Step 10: You should care for your hair.
If you wash and condition your hair regularly, it will look better after a while.Each time you wash your hair, use a leave-in conditioner.Use a low temperature when drying your hair.Straighten your hair with a flat iron.
Step 11: Look at the locks.
You will need to identify areas of new growth that are still loose if you want to lock your hair.When using this method, most of the new growth can be saved.Older locks tend to be closer to the hair than newer ones.This process is the fastest way to get rid of your locks and will take an hour or less.
Step 12: The dreads should be cut near the root.
Cut the locks off one at a time with sharp barber scissors, just above the solid portion of each lock.You will have between 1 and 2 inches of hair on your head.
Step 13: Make sure to wash thoroughly.
You should wash your hair after you no longer have a dreadlock.To remove any residuals, rinse well.The conditioner should be applied to the hair as well.Damage can be repaired with a deep conditioner.It is strongly recommended that you wash and conditioning your hair before doing any further tidying because it will make it easier to brush and even it out later.Don't dry your hair at this point.Only after your hair has been brushed and trimmed can you do it.
Step 14: It's time to brush it out.
Make it as straight as possible by brushing out the remaining hair with a metal comb.Don't expect your hair to be straight.You need to brush out as many tangles as you can.
Step 15: It's time to tidy it up.
You may need to use scissors or clippers to even out the hair on your head.The easiest thing to do is to shave the hair with clippers.
Step 16: Enough time has been set aside.
The method does not require as much time as a full unraveling, but it will take more time than cutting your locks out.Depending on how many locks you have, how old the locks are, and how much hair you want to keep, this process could take anywhere from 2 to 15 hours.
Step 17: How long to leave the hair?
The exact length is yours to decide, but typically, you should save at least 4 to 6 inches (10 to 15 cm) to make this method worth the time.If you want to keep some of your hair, you should use this method.If you have had locks for more than four years, it is best to cut off half of your hair.
Step 18: Cut the dreads in half.
Keep the same amount of dreads intact by using barber scissors to cut them at a time.
Step 19: The remaining locks should be soaked.
Warm water can be used to fill a bucket or sink.Submerging as many of your locks as possible is what you can do if you sit in front of the water.If you want to get the best results, soak your locks for 5 to 10 minutes.It's better to have any amount of soaking time.
Step 20: Well done.
Use your fingers to wash your hair.During this process, use hot water as well.The water should be hot, but not too hot.The build-up that would interfere with the unlocking process should be removed by washing your hair.If you want to continue, rinse your hair out.
Step 21: Make sure the remaining locks are in working order.
Working with them one by one, Rub a little conditioner or specialized lock removal product into each lock.After applying the conditioner, don't rinse it out of your hair.
Step 22: Pick out one lock at a time.
Attach a metal comb to the bottom of the lock.The comb can be used to pick out loops and tangles.Start at the bottom and work your way up the lock.After every 1 inch, remove the loosened hair.When all the locks have been undone, repeat this process on each dread.
Step 23: Again, condition once more.
After getting your hair done, apply conditioner to it.After a few minutes, rinse it out with warm water.Damage to your hair should be repaired with the extra conditioner you apply now.
Step 24: Take care of the ends.
Carefully trim the ends to balance out the loosened hair.It is possible to do this while your hair is still wet.Don't dry your hair before you tidy it up.
Step 25: You need to care for your hair.
If you wash your hair regularly and apply a conditioner after each wash, it will become healthier within a week or two.