A fundamental kitchen skill that will pay off for a wide variety of dishes is learning how to individual garlic.It only takes a few minutes to learn good mincing.With a little practice, you can add garlic to your favorite recipes.
Step 1: The cloves can be removed from the bulb.
You can't use garlic until you prepare the cloves.Press down firmly on the bulb with the palm of your hand.As gentle pressure is applied, the cloves will separate from each other.The loose outer skin can be removed to get to the cloves.Don't discard small cloves of garlic that may be hidden in the peel.The number of cloves is required in most recipes.If not, one medium-sized clove usually contains about a quarter of a pound of garlic.
Step 2: Remove the cloves.
The skin around each clove needs to be removed before it can be used in cooking.There are many ways to do this.One way to remove the hard stem end of the clove is to squeeze it out from its skin using gentle, but steady, pressure.Place the knife blade on top of the clove and press down until you feel the skin release.Place your fingers on the skin to remove it.Don't smash the clove completely, it may cause clove "meat" to mix with the waste.
Step 3: The garlic clove should be sliced in half.
The thinner the slices, the better.Extra care must be taken to avoid cutting yourself since garlic cloves are so small.One trick a chef can use to prevent cutting accidents is to hold the clove of garlic with their fingertips, putting a bend in their knuckles as they press it into the cutting board.An accident is less likely if the side of the knife rests against the knuckle.To get better control over the knife, hold it against the board and use a rocking motion to slice the garlic, rather than moving it up and down.
Step 4: The clove should be sliced into pieces.
If you want to slice it again, turn the clove 90 degrees.Thin cuts across the layers will produce a fine mince.The same technique is used.You should have a lot of garlic cubes when you're done.You just chopped up a clove of garlic.
Step 5: Keep mincing if you wish.
If you mince a clove of garlic, you will get more small pieces, which will give you more flavor and aroma.If the recipe calls for it, keep running your knife back and forth over the pile of garlic to get a better cut, or to eliminate any large pieces that may remain.It's important to remember that garlic is finely chopped into many small pieces.The garlic has been chopped into small pieces.
Step 6: The cloves should be prepared and peel as normal.
If you don't have a knife, you can learn a few alternative ways to mince garlic.Before you start mincing, you'll want to prepare the garlic cloves as normal.The correct number of cloves should be separated from the bulb.The leftover bulb skin should be discarded.If you want to peel the garlic, squeeze the clove out of the skin or crush it with a knife.
Step 7: Try to mincing with a fork.
The tines of a fork are an easy way to mince garlic.This requires some arm strength but works well.If you want to do this, lay the garlic flat on a cutting board and grab a metal fork.The tines of the fork should be pressed into the garlic.The garlic can be pushed through the gaps in the tines.Go in the other direction with the fork.Continue until you get a final mince.Pick up the garlic stem from the scraps of the fork.It's ready to use.
Step 8: You can use a garlic press.
A garlic press is a handy tool that can be used to prepare garlic.The device presses garlic into a paste.The clove should be placed inside the inner metal part of the press.The handles should be squeezed.There are holes on the other side of the press.The garlic material was forced through the press.The garlic is ready to eat.The mortar and pestle is a similar device.
Step 9: Microplaning is a way to plan.
A microplane is a small device that works like a cheese grater.Microplaning a clove of garlic slices it quickly.Rub the garlic against the blades of the microplane.The slices will fall into the bowl.When the garlic is too small to microplane without hurting your fingers, just chop it up or crush it.
Step 10: A food processor is an alternative.
It's worth noting that almost any food processor device should be able to mince garlic.A good mince can be achieved by Pulsing the blades just a few times.Since garlic cloves are so small, it can be difficult to assemble a food processor just to mince one, but this is a good choice if you need to make a larger recipe.