An arbor knot is one of the most basic knots you can tie and is often used to attach fishing reel to fishing spools.A simple overhand knot doesn't provide as much security as a arbor knot.arbor knots are very easy to tie as long as you take your time
Step 1: Attach the string around the knot.
Wrap the free end of the string around the knot.Pull both sides of the string against the object.The ends of the string should point in the same direction.You would wrap the string around your fishing rod if you were tying the knot.
Step 2: Place a 1 in loop at the end of the line.
Cross the free end of the rope or string over to form a loop at the end.
Step 3: The free end of the string can be pulled through the loop.
Pull the free end of the string through the loop until it forms a knot.You should have a small knot at the end of your rope.The overhand knot is one of the most common knots out there.
Step 4: The string can be looped over the mainline.
The mainline is the rope or string on the other side of the object.Bring the end of the string under the mainline so that it forms a loop around it.You can hold the loop with your fingers.The loop should be around 1–2 inches.The main line should be able to move through the loop you created.
Step 5: The string needs to be pulled over the free line.
Take the end of the string and cross the free line again.
Step 6: The end of the string should be pulled through the loop.
To make a slip knot, thread the end of the line through the loop.To tighten the knot, pull on the free end of the string.A slipknot can slide down your rope or string.
Step 7: The knot should be tightened by pulling on the strings.
Pulling on the strings will tighten the slipknot around whatever you are tying the knot to.
Step 8: Take the excess free line out.
To cut the string on the free line, use a pair of scissors or a razor blade.There is slack at the end of the knot if you cut the line or rope.