Common Reasons Your Furnace Pilot Won't Light There are several possible reasons why your gas furnace pilot won't light: an ongoing draft, a faulty thermocouple, an accumulation of dirt, or an inefficient supply.
Why is my water heater not igniting?
https://www.youtube.com/watch?v=jQdlBxtUwcM
Why would a water heater pilot light go out?
Your thermocouple senses when your pilot light is burning. If it senses that your water heater pilot light keeps going out, the thermocouple will shift off the gas supply to the heater. Over time, thermocouples can malfunction, accumulate dust buildup, or the device can get bent away from the pilot light's flame.
Why does my hot water heater igniter not ignite?
If the igniter fails, the burner will not light. To determine if the igniter is defective, first make sure the igniter is getting voltage. If the igniter is getting voltage, but it doesn't glow, this indicates that the igniter is defective and should be replaced.
What do I do if my pilot light won't light?
- Find your gas valve.
- You need to turn the valve to the off position for at least three minutes.
- Once you have had the valve at off for a few minutes, switch it over to pilot setting.
- You will need a match that is lit.
- Set the pilot valve to the on position.
How do you fix a water heater Ignitor?
https://www.youtube.com/watch?v=MuGY9nfcTZA
How do you reset the igniter on a water heater?
https://www.youtube.com/watch?v=05ucgUqUD1k
What do you do if your pilot light won't light?
If the pilot doesn't relight, if it goes out right after lighting or if it goes out repeatedly, by far the most common cause is a bad thermocouple. The good news: You can usually replace a thermocouple for minimal cost and in less than an hour.
What causes the pilot light to go out?
Some of the possible serious reasons for pilot lights to go out include loose or broken gas valves, thermocouples or heat exchangers, faulty venting, low gas pressure, or high winds. If you believe there is a serious problem, don't hesitate to contact a professional.
How do you get a pilot light back on?
- Step 1: Turn off your furnace.
- Step 2: Locate your gas valve.
- Step 3: Hold down the red button.
- Step 4: Light the pilot light.
- Step 5: Let go of the button.
- Step 6: Turn your gas back on.
- Step 7: Turn your furnace back on.
Can you manually light a pilot light?
Use a grill lighter or long match to light the pilot light valve at the bottom of the oven. Some ovens are designed to be manually lit at each use. In this case, slowly turn the temperature knob while holding the flame to the pilot light valve. Close the oven door after the pilot light ignites.
Why would a pilot light just go out?
Improper Venting & Airflow Sometimes a pilot light can go out as a result of some source of wind or air simply blowing it out. If this happens, there could be an issue with how your flue pipe is set up or how your system is venting.