A white cement based wall putty is famously used for interior and exterior walls. It is made using special additives and fillers to multitask as a putty, sealer, and filler over plaster or concrete walls. White cement, minerals, and polymers are mixed together to form a white cement based wall putty.
What is difference between acrylic putty and cement putty?
Acrylic Putty White Cement Based Putty
-------------------------- ---------------------------------------------------------------------------------------------
Appearance: Pale/Off white Appearance: It has a better appearance due to the higher whiteness properties of the product.
Is cement putty waterproof?
Birla White WallSeal Waterproof Putty is a white cement-based putty with 2x water resistance and Active German Silicon Polymers which provides a strong base on a plaster/concrete and mortar wall surface before application of topcoat paint or distemper and protects your walls from water.
How do you apply putty to a wall?
Apply putty to small cracks and holes with a small putty knife. Scoop up some putty onto the blade of a small—roughly 3–4 in (7.6–10.2 cm) wide—putty knife and press the putty into each small crack or hole. Then scrape the blade over the area horizontally and vertically to remove excess putty.
How do you use putty mix?
- Stir continuously by hand or by an electric putty mixer for about 10-15 minutes.
- Make sure that it does not create lumps while mixing.
Can white cement be used as putty?
On the interior walls, no white cement putty application can ever match the POP finish. Even if one has to apply putty following care should be taken. The surface should always be moist before application of putty but Sadly in 95% cases the curing is not done.21 Apr 2017
What can be used instead of white cement?
Fly ash has been commonly used to replace cement, however, the amount of fly ash is much limited, say, than Portland cement. Additionally, its drying shrinkage probably higher than OPC, hence shrinkage-induced crack resistance would be less than OPC.
How do you use white cement putty?
Mixing - Birla White WallCare Putty should be mixed slowly with 36-38% clean water to make a paste. It's very important that water is added in this cement putty to make the mix and not vice versa. It should be mixed for at least 10-15 minutes until a uniform paste is formed.
What is Acrylic putty used for?
The putty can be used on plastered walls, concrete, brickwork, and asbestos. Since it is an undercoat, acrylic putty is available only in white shade. Acrylic putty smoothens and levels the bare walls by covering their cracks and dents.