LOCTITE® SF 7471 is transparent, yellow to amber liquid activator used where increased cure speed of LOCTITE anaerobic products is required. It is especially recommended for applications with passive metals or inert surfaces and with large bond gaps.
How do I apply Loctite?
- Make sure nuts and bolts are clean and free from oil or dirt. ...
- Apply a few drops of Loctite threadlocker on the bolt, where the nut engagement area will be. ...
- Twist on the nut to the desired point and allow cure time to be achieved (Full cure in 24 hours).
How do you apply Loctite Primer?
- Clean parts of contamination. If necessary, spray LOCTITE® SF 7649™ Primer onto threaded parts (male and female). ...
- Apply a band of LOCTITE® Thread Sealant to male threads starting one to two threads from end of pipe. Assemble parts snugly. ...
- If initial pressure exceeds 1000 psi*, wait 30 minutes before pressurizing.
How do you apply Loctite tape?
https://www.youtube.com/watch?v=Xrme9OLqjds
What does Loctite Activator do?
LOCTITE® SF 7649 is a solvent-based activator for surface preparation that provides for low temperature curing. LOCTITE® SF 7649 is designed to promote the curing speed of LOCTITE® anaerobic adhesives and sealants without any significant loss of joint strength.
Do you need activator for Loctite?
With any one of these, in most of the typical cases, the bonding (threadlocking included) will work just fine without the use of any activator. You might still optionally use it, usually in the cases when you want to speed up the cure and achieve handling strength faster. But it will also work just fine without.
What is Loctite sf7649 used for?
LOCTITE® SF 7649 is designed to promote the curing speed of LOCTITE anaerobic adhesives and sealants without any significant loss of joint strength. It is especially recommended for applications with passive metals or inert surfaces and with large bond gaps.