Ford introduced the 239 cu in (3.9 L) V8-99A engine with 3.1875 by 3.75 in (80.96 by 95.25 mm) bore and stroke and 6.15:1 compression in 1939. It produced 95 hp (71 kW) and 170 lb⋅ft (230 N⋅m).
How much horsepower can you get out of a flathead Ford engine?
It was meant to be a carthorse, not a racehorse. Nevertheless, the flathead is the little engine that could. Despite having three rather than five main bearings, the flathead has stayed the course. With some exotic tuning, it has been known to produce 700 hp, and not just for short bursts.
How fast was a 1934 V8 Ford?
65 miles per hour
How much power did the flathead V8 make?
In 1953, Ford made the final flathead V-8. It displaced 3.9 liters and made 110 hp. As engineers sought more power, Ford scrapped the design in favor of an overhead-valve engine.
Is a Ford flathead reliable?
Steadily improved through 1953, with millions produced, the flathead achieved acceptable reliability. Ford solved most of the flathead's ills over time, upgrading ignition, redesigning water pumps, refining carburetion and boosting displacement—to 239 cid and on to 255 cid in the '49-53 Mercury.
Can you supercharge a flathead V8?
T. superchargers, and stroker kits are tweaked and available for Ford 21- and 24-stud flathead builds. This 296-inch supercharged, 24-stud 59A flathead makes 250 hp and 330 lb-ft of torque and was built for a 1939 Ford Tudor Standard.
Can you supercharge a flathead engine?
Though naturally aspirated flatheads can get by with the stock iron main caps, the elevated cylinder pressure brought on by supercharging mandates the use of billet steel upgrades. Despite its spindly looking three-main design, Mike says the lower end is actually very rugged.
Why did they stop making flathead engines?
In 1953, Ford made the final flathead V-8V-8The S-V8 is powered by a Ford Mustang sourced 4·6-litre (4601 cc), 32-valve, four-cam, V8 engine producing 325 bhp (242 kW; 330 PS), with a top speed of 160 mph (260 km/h) and 0-60 mph in less than five seconds.https://en.wikipedia.org › wiki › Jensen_S-V8Jensen S-V8 - Wikipedia. It displaced 3.9 liters and made 110 hp. As engineers sought more power, Ford scrapped the design in favor of an overhead-valve engine. Thus the flathead V-8's tenure came to end.
Why do Ford flatheads overheat?
All Flatheads generate more heat because the exhaust gases spend more time exiting the block. The Ford V-8V-8The S-V8 is powered by a Ford Mustang sourced 4·6-litre (4601 cc), 32-valve, four-cam, V8 engine producing 325 bhp (242 kW; 330 PS), with a top speed of 160 mph (260 km/h) and 0-60 mph in less than five seconds.https://en.wikipedia.org › wiki › Jensen_S-V8Jensen S-V8 - Wikipedia employs two water pumps for cooling, so you actually have two cooling systems sharing a common reservoir known as the radiator.Jun 1, 2010
What is an 8BA flathead?
In general, the latter year flatheads were commonly referred to as the "8BA" type for Ford and "8CM" for Mercury. The truck version was identified as an "8RT". Later 1952 and '53 Fords and Mercurys were known as "EAB" and "EAC" respectively. These markings are generally cast into the cylinder heads.