What kind of screws do you use for Hardie board siding?
What kind of screws do you use for Hardie board siding?
James Hardie recommends 1-1/4'' long galvanized or STAINLESS steel roofing nails or 1-1/4'' long ribbed waferhead screws in compliance with the tile industry. It is 8-18 x 3/8'' HD.
Can you screw into Hardie board siding?
James Hardie Building Products recommends keeping nails or screws at least 3/8 inch from the end of a plank. ... Drill pilot holes, at each mark, one-quarter to one-half inch deep, to make it easier to insert screws and prevent cracking the siding. Align the bracket holes with the pilot holes in the siding.
Are there special screws for Hardie board?
Backer-On 1-1/4 in. Cement Board Screws are designed for attaching HardieBacker or equivalent fiber cement backerboard to wood or light gauge steel studs.
What type of screws do you use for fiber cement siding?
Fiber cement siding can be nailed by hand or with a pneumatic nailer. It can also be attached using corrosion resistant screws. Use hot-dipped galvanized or stainless steel nails.
Can you use screws with Hardie siding?
HardiePlank® lap siding may be used with fasteners approved by ICC-ES ESR-2290 spaced in accordance with the Wind Load Tables. Fasteners must be corrosion resistant, galvanized or stainless steel. ... Fasteners shall be installed between 1 in. and 3/4 in.
What kind of screws do you use for cement siding?
Fasteners must be corrosion resistant, galvanized or stainless steel. James Hardie prefers and recommends installation of HardiePlank® lap siding by the blind nailing technique, such that fasteners are hidden by the course above.
Can I use screws on Hardie trim?
ET&F or equivalent fasteners or screws may be used to attach HardieTrim boards to steel frame construction. Fastening instructions are similar for all applications.
What kind of screws do you use for Hardibacker?
Cement Board Screws are designed for attaching HardieBacker or equivalent fiber cement backerboard to wood or light gauge steel studs.
What screws should I use for Hardie siding?
James Hardie recommends 1-1/4'' long galvanized or STAINLESS steel roofing nails or 1-1/4'' long ribbed waferhead screws in compliance with the tile industry. It is 8-18 x 3/8'' HD.
Can you screw into Hardiplank siding?
James Hardie Building Products recommends keeping nails or screws at least 3/8 inch from the end of a plank. ... Drill pilot holes, at each mark, one-quarter to one-half inch deep, to make it easier to insert screws and prevent cracking the siding. Align the bracket holes with the pilot holes in the siding.