Fasteners must be corrosion resistant, galvanized or stainless steel. James Hardie prefers and recommends installation of HardiePlank® lap siding by the blind nailing technique, such that fasteners are hidden by the course above. Fasteners shall be installed between 1 in. and 3/4 in.
Can you put screws in Hardie plank?
James Hardie Building Products recommends keeping nails or screws at least 3/8 inch from the end of a plank. ... Drill pilot holes, at each mark, one-quarter to one-half inch deep, to make it easier to insert screws and prevent cracking the siding. Align the bracket holes with the pilot holes in the siding.
What kind of screws do you use for Hardibacker?
Cement Board Screws are designed for attaching HardieBacker or equivalent fiber cement backerboard to wood or light gauge steel studs.
What screws can I use for fiber cement siding?
Fasteners must be corrosion resistant, galvanized or stainless steel. James Hardie prefers and recommends installation of HardiePlank® lap siding by the blind nailing technique, such that fasteners are hidden by the course above. Fasteners shall be installed between 1 in. and 3/4 in.
Can you use screws for HardiePlank siding?
HardiePlank® lap siding may be used with fasteners approved by ICC-ES ESR-2290 spaced in accordance with the Wind Load Tables. Fasteners must be corrosion resistant, galvanized or stainless steel. ... Fasteners shall be installed between 1 in. and 3/4 in.
Can I use screws on Hardie trim?
ET&F or equivalent fasteners or screws may be used to attach HardieTrim boards to steel frame construction. Fastening instructions are similar for all applications.
Should I nail or screw Hardie board?
James Hardie prefers and recommends installation of HardiePlank® lap siding by the blind nailing technique, such that fasteners are hidden by the course above. Fasteners shall be installed between 1 in. and 3/4 in.
How do you screw HardiePlank?
Blind nailing is the preferred installation method for HardiePlank. The term applies to a nailing/screwing method for joining HardiePlank planks to hide nail or screw fasteners. Use a Number 8, 1-1/4-inch-long by 0.375-inch-wide (HD) ribbed wafer-head (or equivalent) screw on steel studs.
What kind of screws do I use for Hardie plank?
James Hardie recommends 1-1/4'' long galvanized or STAINLESS steel roofing nails or 1-1/4'' long ribbed waferhead screws in compliance with the tile industry. It is 8-18 x 3/8'' HD.