Based on the current and voltage rating of the meter and breaker, #4 size AWG copper wire is the highly suggested type and size of wire.17 oct 2021
What wire goes from meter to panel?
SE-U is most commonly used for service entrance applications, to connect the meter socket to the main breaker panel. It is also commonly used for overhead service drop applications, to connect the overhead service cable to the meter socket.
What would be the minimum service entrance cable size for a 200 amp supply?
Installation of 200 amp electrical service needs a #2/0 AWG copper wire or #4/0 AWG for aluminum or copper-clad wire inside a 3″ conduit. Wiring a 200 amp electrical service is not a DIY job. It often requires a permit and professional installation by a qualified electrician following local electrical codes.20 jun 2021
How many wires do I need for a 200 amp service?
Service or Feeder Rating (Amperes) Copper Wire (AWG or kcmil) Aluminum or Copper-Clad Aluminum Wire (AWG or kcmil)
---------------------------------- -------------------------- ----------------------------------------------------
125 2 1/0
150 1 2/0
175 1/0 3/0
200 2/0 4/0
What size hub do I need for a 200 amp service?
200 Amp overhead meter base will be 14” high x 8” wide x 3 1/2” deep, minimum size with 2” hub. *The electrical service must pass inspection by an approved electrical inspection agency before it will be energized.17 jun 2013
What size wire do I need for a 200 amp sub panel?
Per Article 250 of the NEC , The minimum size for a grounding conductor for a circuit protected by a 200 amp breaker is #6 copper or #4 Aluminum.