The heating element warms the air before it enters the dryer drum. Over time, the heating element can burn out, causing the dryer not to heat. To determine if the heating element has burned out, use a multimeter to test it for continuity. ... Over time, the heating element can burn out, causing the dryer not to heat.
What would cause a gas dryer not to heat up?
Common reasons for an electric or gas dryer not heating are a tripped circuit breaker, clogged vent, and no gas flow. Other potential reasons include a faulty thermal fuse and broken heating element.Apr 2, 2019
Why is my Kenmore dryer blowing cold air?
With electrically heated dryers, the most common problems are a defective thermostat or an open heating element. ... In some cases, the high-limit thermostat is a thermal fuse; if this thermal fuse has burned open, the dryer blows cold air. Thermal fuses do not reset, and need to be replaced.
How do I know if my gas dryer solenoid is bad?
Locate the gas valve and remove the coil(s) and test them using a multimeter, if you get a resistance reading on the meter of 1000-2000 ohms, the coil is bad and must be replaced.
Why won't my Kenmore Elite gas dryer heat up?
The first thing you should do when a gas dryer fails to heat is make sure the gas valve is on. ... It's also worth your while to turn off the gas valve, disconnect the gas hose and turn the valve on momentarily to make sure gas is flowing, because the pipe might have an obstruction.
What can cause a gas dryer to stop heating?
Common reasons for an electric or gas dryer not heating are a tripped circuit breaker, clogged vent, and no gas flow. Other potential reasons include a faulty thermal fuse and broken heating element.Apr 2, 2019
Why is my gas dryer only blowing cold air?
One of the most common reasons your tumble dryer decides to blow out cold air instead of hot is, rather ironically, because it has overheated. ... If your tumble dryer does not have a reset button it is likely you will need to replace your thermostat and thermal overload cut-out (TOC).May 15, 2017